9.4 Silhs: a Monte Carlo Interface between Clouds and Microphysics

نویسندگان

  • Vincent E. Larson
  • Carsten Harlass
چکیده

Clouds exhibit spatial variability on a range of scales, and this variability influences microphysical processes such as drizzle formation (Pincus and Klein 2000; Larson et al. 2001). For this and other reasons, large-scale models may benefit from including the effects of subgrid cloud variability on microphysical process rates. For instance, feeding the fraction of a grid box occupied by cloud into a microphysics parameterization may help better characterize the moist parts of a grid box in which drizzle forms. Accuracy may also be improved by including information on within-cloud variability. Unfortunately, embedding information about subgrid cloud variability in microphysics schemes is laborious. In a model such as the Weather Research and Forecasting (WRF) model, which contains many microphysics schemes, embedding subgrid information separately in each microphysics scheme would be especially time consuming. In this paper, we test an alternative Monte Carlo method of driving microphysics schemes with information about subgrid variability. The method assumes that the distribution of subgrid variability is available for each grid box and time step. It then draws samples from that distribution. The sample points are fed, one by one, into the microphysics scheme in use. Finally, the process rates from each call to the microphysics are averaged and fed back into the simulation. This Monte Carlo metholodogy is related to the McICA method which has been used to drive radiative parameterizations (e.g. Barker et al. 2002; Pincus et al. 2003; Räisänen et al. 2004; Räisänen and Barker 2004; Räisänen et al. 2005; Pincus et al. 2006). For reasons to be discussed below, we call this method the Subgrid Importance Latin Hypercube Sampler (SILHS). SILHS separates the calculation of subgrid variability and the calculation of local microphysical process rates. Because of this, SILHS can include effects of subgrid variability without requiring modifications to the microphysics code itself. We test SILHS by performing month-long, 3D simulations of marine low clouds off the coast of Chile. These clouds were observed during the VAMOS Ocean-Cloud-Atmosphere-Land Study – Regional Experiment (VOCALS-REx) (Wood et al. 2011). We find that the use of SILHS noticeably increases cloud cover.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Supplying Local Microphysics Parameterizations with Information about Subgrid Variability: Latin Hypercube Sampling

One problem in computing cloud microphysical processes in coarse-resolution numerical models is that many microphysical processes are nonlinear and small in scale. Consequently, there are inaccuracies if microphysics parameterizations are forced with grid box averages of model fields, such as liquid water content. Rather, the model needs to determine information about subgrid variability and in...

متن کامل

CT-Based Brachytherapy Treatment Planning using Monte Carlo Simulation Aided by an Interface Software

Introduction: In brachytherapy, radioactive sources are placed close to the tumor, therefore, small changes in their positions can cause large changes in the dose distribution. This emphasizes the need for computerized treatment planning. The usual method for treatment planning of cervix brachytherapy uses conventional radiographs in the Manchester system. Nowadays, because of their advantages ...

متن کامل

The impact of aerosols on polarized sky radiance: model development, validation, and applications

Although solar radiation initially is unpolarized when entering the Earth’s atmosphere, it is polarized by scattering processes with molecules, water droplets, ice crystals, and aerosols. Hence, measurements of the polarization state of radiation can be used to improve remote sensing of aerosols and clouds. The analysis of polarized radiance measurements requires an accurate radiative transfer ...

متن کامل

Monte Carlo characterization of photoneutrons in the radiation therapy with high energy photons: a Comparison between simplified and full Monte Carlo models

Background: The characteristics of secondary neutrons in a high energy radiation therapy room were studied using the MCNPX Monte Carlo (MC) code. Materials and Methods: Two MC models including a model with full description of head components and a simplified model used in previous studies were implemented for MC simulations. Results: Results showed 4-53% difference between full and wit...

متن کامل

The comparison between 6 MV Primus LINAC simulation output using EGSnrc and commissioning data

Introduction: Monte Carlo calculation method is considered to be the most accurate method for dose calculation in radiotherapy. The purpose of this research is comparison between 6 MV Primus LINAC simulation output with commissioning data using EGSnrc and build a Monte Carlo geometry of 6 MV Primus LINAC as realistically as possible. The BEAMnrc and DOSXYZnrc (EGSnrc package) M...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2013