Numerical Descriptions of Hot Flow Behaviors across Transus for as-Forged Ti–10V–2Fe–3Al Alloy by LHS-SVR and GA-SVR and Improvement in Forming Simulation Accuracy
نویسندگان
چکیده
Guo-Zheng Quan 1,*, Zhi-Hua Zhang 1, Le Zhang 1 and Qing Liu 2 1 State Key Laboratory of Mechanical Transmission, School of Material Science and Engineering, Chongqing University, Chongqing 400044, China; [email protected] (Z.-H.Z.); [email protected] (L.Z.) 2 China National Erzhong Group Co., Deyang 618000, Sichuan, China; [email protected] * Correspondence: [email protected]; Tel./Fax: +86-023-6511-1493
منابع مشابه
Metastable Beta TitaniumAlloys: Tuning Their Beta Phase Stability and Low-Temperature Martensitic Trans- formation
This research focuses on the stability of three metastableβ titanium alloys – Ti-10V-1Fe-3Al (T i −1013), Ti-10V-2Cr-3Al (T i −102Cr 3) and Ti-10V-2Fe-3Al-B (T i −1023B). In the first stage of the work, new β+ (α+β) heat treatment schemes were designed on the basis of Thermo-Calc® simulations and previous research work and carried out to such an extent that the β phase stability is tuned to the...
متن کاملPlasticity Induced Transformation in a metastable β Ti-1023 alloy by controlled heat treatments
Investigations into the possibility of improving the strength-ductility relation in a metastable β-titanium alloy (Ti-10V-2Fe-3Al) through plasticity induced transformation (PiTTi) have been carried out. Various heat treatments in the β and/or α+β condition were performed to study their influence on both the microstructure and solute partitioning, which eventually control the PiTTi effect. Stre...
متن کاملApplication of T-shape Friction T test for Ti-6Al-4V Alloy at Elevated Temperatures
There are several parameters that have significant influence in metal forming process. One of the most important of them is friction coefficient. Friction can change the pattern of metal flow and the force needed for deformation. It is necessary to determine the friction coefficient to study the effect of friction on metal forming process. This study is concerned with numerical and experimental...
متن کاملThe Effects of Forming Parameters on the Single Point Incremental Forming of 1050 Aluminum Alloy Sheet
The single point incremental forming (SPIF) is one of the dieless forming processes which is widely used in the sheet metal forming. The correct selection of the SPIF parameters influences the formability and quality of the product. In the present study, the Gurson-Tvergaard Needleman (GTN) damage model was used for the fracture prediction in the numerical simulation of the SPIF process of alum...
متن کاملOn the Effects of Hot Forging and Hot Rolling on the Microstructural Development and Mechanical Response of a Biocompatible Ti Alloy
Zr, Nb, and Ta as alloying elements for Ti alloys are important for attaining superior corrosion resistance and biocompatibility in the long term. However, note that the addition of excess Nb and Ta to Ti alloys leads to higher manufacturing cost. To develop low-cost manufacturing processes, the effects of hot-forging and continuous-hot-rolling conditions on the microstructure, mechanical prope...
متن کامل