Mechanisms of femtosecond laser- induced refractive index modification of poly(methyl methacrylate)
نویسندگان
چکیده
Publisher statement: This paper was published in Journal of the Optical Society of America B-Optical Physics and is made available as an electronic reprint with the permission of OSA. The paper can be found at the following URL on the OSA website: http://www.opticsinfobase.org/abstract.cfm?uri=josab-27-1-107. Systematic or multiple reproduction or distribution to multiple locations via electronic or other means is prohibited and is subject to penalties under law.
منابع مشابه
NUV and NIR Femtosecond Laser Modification of PMMA
Substantial refractive index changes in clinical grade poly(methyl methacrylate) (PMMA) with both femtosecond NIR (800 nm) and NUV (387 nm) laser pulses are demonstrated, enabling volume gratings and waveguides in bulk PMMA. In the NIR, temporal pulse duration is shown to be critical, with modification efficiency increasing rapidly as pulse duration decreases below 200 fs. On the other hand, in...
متن کاملMeasurement and comparison of the temperature-dependence of refractive index of water and Plexiglas phantoms by interferometry method for their use in optical calorimetry
In radiation calorimetry by using laser beams and interferometry setups, variations induced by dose absorption in phantom can be precisely measured. Dose absorption and the induced temperature change result in refractive index variation of the material. In order to be able to measure the low amount of absorbed dose in the phantom, temperature dependence of refractive index of the material must ...
متن کاملMultiple Beam Internal Structuring of Poly(methyl methacrylate)
Spatial light modulator addressed with computer generated holograms is used to diffract femtosecond laser pulses into > 15 parallel beams and focused simultaneously inside poly(methyl methacrylate) (PMMA) for high throughput 3D refractive index modification. Uniform modification throughout the structure is demonstrated and used to create a 19 μm pitch, 5 × 5 × 3.5 mm 3 thick volume grating in <...
متن کاملFemtosecond laser fabrication of tubular waveguides in poly(methyl methacrylate).
Femtosecond laser direct writing is employed for the fabrication of buried tubular waveguides in bulk poly(methyl methacrylate). A novel technique using selective chemical etching is presented to resolve the two-dimensional refractive-index profile of the fabrication structures. End-to-end coupling in the waveguides reveals a near-field intensity distribution that results from the superimpositi...
متن کاملFemtosecond laser written low-loss single-mode waveguides in PMMA
Ultrafast laser inscription is a standard technique to fabricate embedded waveguides in glasses or crystals. Tightly focused femtosecond laser-pulses induce an increase in refractive index inside the material via non-linear absorption. By moving the sample through the focus virtually arbitrary threedimensional paths can be created. The transfer of this technique to polymers has already delivere...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2009