Cathodic Arc Synthesis of Ti-Si-C-N Thin Films Plasma Analysis and Microstructure Formation

نویسنده

  • Anders Eriksson
چکیده

ii The cover image is based on a photograph of arc spots moving on the surface of a Ti cathode, taken during the first experimental session in our new PVD research system, Hydra. The explosive plasma generation in the arc spots is central to the cathodic arc deposition technique, studied and used extensively for synthesis in the Thesis. Abstract This Thesis explores the arc deposition process and films of Ti-Si-C-N, inspired by the two ternary systems Ti-SiN and TiC -N, both successfully applied as corrosion and wear resistant films. The correlation between cathode, plasma, and film properties are studied for a comprehensive view on film formation. Novel approaches to adapt arc deposition to form multi-element films are investigated, concluding that the source of C is not a determining factor for film growth. Thus, cubic-phase films of similar properties can be synthesized from processes with either 1) ternary Ti-Si-C cathodes, including the Ti3SiC2 MAX phase, in N2 atmosphere or 2) Ti-Si cathodes in a mixture of N2 and CH4. With the Ti3SiC2 cathodes, superhard (45-50 GPa) cubic-phase (Ti,Si)(C,N) films can be deposited. The structure is nanocrystalline and feather-like, with high Si and C content of 12 and 16 at%, respectively. To isolate the effects of Si on film structure, magnetron sputtered Ti-SiN films of comparatively low defect density was studied. These films show a strong preference for {200} growth orientation, and can be grown as a single phase solid solution on MgO(001) substrates up to ~9 at% Si, i.e. considerably higher than the ~5 at% Si above which a feather-like nanocrystalline structure forms in arc deposited films. On (011) and (111) growth surfaces, the films self-organize into TiN columns separated by segregated crystalline-to-amorphous SiNx. The conditions for film growth by arc were investigated through plasma studies, showing that plasma properties are dependent on cathode composition as well as phase structure. Plasma generation from Ti-Si cathodes, with up to 25 at% Si, show higher average ion charge states of Ti and Si compared to plasma from elemental cathodes, which may be related to TiSix phases of higher cohesive energies. The ion energy distributions range up to 200 eV. Furthermore, compositional discrepancies between plasma ions and film infer significant contributions to film growth from Si rich neutral species. This is further supported by depositions with a macroparticle filter, intended for growth of films with low surface roughness, where Si and C contents lower …

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Characterization of TiN, CrN and (Ti, Cr) N Coatings Deposited by Cathodic ARC Evaporation

In this investigation PVD Ti-Cr)N coatings were deposited on hardened and tempered tool steel substrates using reactive arc evaporation. Physical and mechanical properties of coatings such as roughness, thickness, phase composition, hardness and modulus young and coefficient friction were evaluated. Phase compositions were studies by X-ray diffraction method. The surface microstructure and morp...

متن کامل

Comparison of Properties of Ti/TiN/TiCN/TiAlN Film Deposited by Cathodic Arc Physical Vapor and Plasma-assisted Chemical Vapor Deposition on Custom 450 Steel Substrates

This study investigated the effects of deposition techniques on the microstructural and tribological properties of Ti/TiN/TiCN/TiAlN multilayer coatings onto a Custom 450 steel substrate. The coatings were produced using cathodic arc physical vapor deposition (CAPVD) and plasma-assisted chemical vapor deposition (PACVD). The microstructural of the coatings was evaluated using (SEM), and phase f...

متن کامل

Capability of X-ray diffraction for the study of microstructure of metastable thin films

Metastable phases are often used to design materials with outstanding properties, which cannot be achieved with thermodynamically stable compounds. In many cases, the metastable phases are employed as precursors for controlled formation of nanocomposites. This contribution shows how the microstructure of crystalline metastable phases and the formation of nanocomposites can be concluded from X-r...

متن کامل

Structural characteristics and tribological properties of TiAlCr(Si)CN nanocomposite films coated on the SPK 1.2080 tool steel using PVD technique

In the present work, structural characteristics and tribological properties of the Ti-Al-Cr-(Si)-C-N nanocomposite films coated on the SPK 1.2080 tool steel byPVD technique have been investigated. The PVD coating process was carried out using Ti (Si) Al and CrAl cathodes at 150 A current, 40 V bias and (Ar)0.1(CH4)0.45(N2)0.45 gas mixture for 50 min. Evaluations were conducted by OM, FESEM, AFM...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2012