Contact and proximity lithography using 193nm Excimer Laser in Mask Aligner
نویسندگان
چکیده
In this paper we describe the use of an Excimer laser for full-field lithography in a Mask Aligner. The DUV light from the Excimer laser is homogenized by using micro lens based optical integrators instead of a macro lens-array. A simulation of the intensity distribution for 5 μm squares was performed to visualize the diffraction effects and to show the potential of 193 nm illumination. It is demonstrated that compared to the conventional homogenization optics the MO Exposure Optics further improves the illumination uniformity, calculated as 1.8% for MO Exposure Optics and 2.9% for the A-Optics. Moreover the improved optical setup allows a modification of the angular spectrum by using exchangeable illumination filter plates (IFP). Compared to the A-Optics the main improvement effect of MO Exposure Optics is detectable in the patterning of layouts containing critical dimension from 8 μm down to 2 μm.
منابع مشابه
Advanced mask aligner lithography: new illumination system.
A new illumination system for mask aligner lithography is presented. The illumination system uses two subsequent microlens-based Köhler integrators. The second Köhler integrator is located in the Fourier plane of the first. The new illumination system uncouples the illumination light from the light source and provides excellent uniformity of the light irradiance and the angular spectrum. Spatia...
متن کاملHalf-tone proximity lithography
The half-tone lithography using pixilated chromium masks in a projection stepper is an established technology in microoptics fabrication. However, the projection lithography tool is comparably expensive and the achievable lateral resolution is typically limited. By using pixel diffraction effects, binary and continuous profile lithography with submicron resolution can be installed on a conventi...
متن کاملResolution enhancement for advanced mask aligner lithography using phase-shifting photomasks.
The application of the phase-shift method allows a significant resolution enhancement for proximity lithography in mask aligners. Typically a resolution of 3 µm (half-pitch) at a proximity distance of 30 µm is achieved utilizing binary photomasks. By using an alternating aperture phase shift photomask (AAPSM), a resolution of 1.5 µm (half-pitch) for non-periodic lines and spaces pattern was dem...
متن کامل25nm Immersion Lithography at a 193nm Wavelength
The physical limitations of lithographic imaging are ultimately imposed by the refractive indices of the materials involved. At oblique collection angles, the numerical aperture of an optical system is determined by nsin(θ) , where n is the lowest material refractive index (in the absence of any refractive power through curvature). For 193nm water immersion lithography, the fluid is the limitin...
متن کاملImmersion lithography with numerical apertures above 2.0 using high index optical materials
The progress of optical lithography has approached the sub-30 nm regime using 193nm excimer lasers as the exposure sources. To increase the numerical aperture (NA) further, many issues, especially those related to materials, need to be addressed. In this paper, we present the analytical and experimental results of oblique two-beam lithography with sapphire (Al2O3) as the optical material. At 19...
متن کامل