Friction and Wear of Self-Lubricating Materials for Hydropower Applications under Different Lubricating Conditions
نویسندگان
چکیده
Self-lubricating bearings in hydropower applications are often lubricated with water under boundary lubricating conditions. Polyhydric alcohols replacing water have shown the potential to reduce both friction and wear. The objective of this work is, therefore, to evaluate the effect of a polyhydric alcohol-based environmentally-acceptable lubricant (EAL) on the friction and wear of self-lubricating materials for conformal contacts under boundary lubricating conditions. The lubricating properties of four commercially-available self-lubricating bearing materials were investigated under three different lubricating conditions: dry, water and a new polyhydric alcohol-based EAL. Bearing materials include one metallic composite and three polymer composites. A reciprocating motion test rig was used to evaluate the wear and friction properties. Surface analysis was performed by scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), and optical profilometry. Results show that the wear rate for the polymer composites is increased when water is present compared to dry operating conditions. The new polyhydric alcohol-based EAL substantially improves both friction and anti-wear performance of all four self-lubricating bearing materials compared to both dry and water conditions. Surface analysis indicates that the material transfer to the counter-surface is limited when the polyhydric alcohol-based EAL is used.
منابع مشابه
Study on Tribological Characteristics of Self-lubricating AA2218-Fly ash-White graphite Composites
In the present scenario composite materials are extensively used for structural applications in automobile and aerospace industries. Composite material exhibits a high strength to weight ratio, improved hardness, reduced weight and low coefficient of friction. Because of their enhanced tribological properties helps to achieve low manufacturing cost and superior performance. The present research...
متن کاملThe tribological properties of Cu-Ni3Al-MoS2 composite coating deposited by magnetron sputtering
In industrial applications, most materials are exposed to wear and friction because multiple conditions are used. However, the tribological properties of these materials can be improved with different techniques. One such technique that improves the frictional property of a surface is the use of self-lubricating coatings. In this study, multicomponent coatings of nominal composition Cu-Ni3Al-Mo...
متن کاملSelf-lubricating, low-friction, wear-resistant Al-based quasicrystalline coatings
After gas atomization, a quasicrystalline powder based on aluminium was used to prepare a thick coating by high-velocity oxygen-fuel flame torch spraying. This layer was deposited on top of a bond-coat layer on a steel plate. A post-spraying annealing treatment turned the two layers to their stable state, a γ-brass crystal and an icosahedral quasicrystal, respectively. The projection parameters...
متن کاملSelf-organization at the frictional interface for green tribology.
Despite the fact that self-organization during friction has received relatively little attention from tribologists so far, it has the potential for the creation of self-healing and self-lubricating materials, which are important for green or environment-friendly tribology. The principles of the thermodynamics of irreversible processes and of the nonlinear theory of dynamical systems are used to...
متن کاملWear and Friction Analysis of Sintered Metal Powder Self Lubricating Bush Bearing
Abstract—Powder metallurgy (P/M) is the only economic way to produce porous parts/products. P/M can produce near net shape parts hence reduces wastage of raw material and energy, avoids various machining operations. The most vital use of P/M is in production of metallic filters and self lubricating bush bearings and siding surfaces. The porosity of the part can be controlled by varying compacti...
متن کامل