Laser Light Induced Transformation of Molybdenum Disulphide-Based Nanoplatelet Arrays

نویسندگان

  • Arūnas Jagminas
  • Gediminas Niaura
  • Rokas Žalnėravičius
  • Romualdas Trusovas
  • Gediminas Račiukaitis
  • Vitalija Jasulaitiene
چکیده

One-pot hydrothermal synthesis of MoS2 nanoplatelet arrays on various substrates is perhaps the most promising approach to fabricate efficient electrocatalysts for hydrogen evolution reaction. However, the main challenges in this synthesis remain the purity and crystallinity of MoS2. In this study, we show for the first time that irradiation of amorphous, defect-rich MoS2 nanoplatelets with a green nanosecond laser at a proper irradiation dose, ca ≤0.35 J cm-2, can significantly improve the crystallinity and purity of MoS2 nanoplatelets. The effect was confirmed by Raman spectroscopy investigations demonstrating a surprising intensity increase of the A1g and modes after the laser irradiation. Further increase of irradiation energy, however, resulted in the photocorrosion and destruction of MoS2 nanoplatelets. The variation of A1g and Raman mode intensities ratio depending on the green light irradiation dose was also presented and is discussed below.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Corrigendum: Optoelectronic crystal of artificial atoms in strain-textured molybdenum disulphide

The isolation of the two-dimensional semiconductor molybdenum disulphide introduced a new optically active material possessing a band gap that can be facilely tuned via elastic strain. As an atomically thin membrane with exceptional strength, monolayer molybdenum disulphide subjected to biaxial strain can embed wide band gap variations overlapping the visible light spectrum, with calculations s...

متن کامل

High rate and durable, binder free anode based on silicon loaded MoO3 nanoplatelets

In order to make fast-charging batteries a reality for electric vehicles, durable, more energy dense and high-current density resistant anodes need to be developed. With such purpose, a low lithiation potential of 0.2 V vs. Li/Li(+) for MoO3 nanoplatelet arrays is reported here for anodes in a lithium ion battery. The composite material here presented affords elevated charge capacity while at t...

متن کامل

Pressure-induced semiconducting to metallic transition in multilayered molybdenum disulphide.

Molybdenum disulphide is a layered transition metal dichalcogenide that has recently raised considerable interest due to its unique semiconducting and opto-electronic properties. Although several theoretical studies have suggested an electronic phase transition in molybdenum disulphide, there has been a lack of experimental evidence. Here we report comprehensive studies on the pressure-dependen...

متن کامل

Exploring atomic defects in molybdenum disulphide monolayers

Defects usually play an important role in tailoring various properties of two-dimensional materials. Defects in two-dimensional monolayer molybdenum disulphide may be responsible for large variation of electric and optical properties. Here we present a comprehensive joint experiment-theory investigation of point defects in monolayer molybdenum disulphide prepared by mechanical exfoliation, phys...

متن کامل

Dichroic spin–valley photocurrent in monolayer molybdenum disulphide

The aim of valleytronics is to exploit confinement of charge carriers in local valleys of the energy bands of semiconductors as an additional degree of freedom in optoelectronic devices. Thanks to strong direct excitonic transitions in spin-coupled K valleys, monolayer molybdenum disulphide is a rapidly emerging valleytronic material, with high valley polarization in photoluminescence. Here we ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 6  شماره 

صفحات  -

تاریخ انتشار 2016