FPGA Implementation for Minimum Differential Feedback of MIMO-OFDM Transreceiver System
نویسنده
چکیده
The latest Research Trend in wireless communication is implementing wireless system on SDR (Software Define Radio), so the SDR implementation of MIMO-OFDM receiver with channel state information is presented in this paper. Here we use Xilinx 13.1 Spartan 3 xc3s400pq208 FPGA device. The simulation results are obtained for 2x2 MIMO-OFDM receiver system in which we have implemented channel estimation, FFT, deinterleaver and decoder blocks in VHDL. The performance analysis of the receiver implementation is presented with resource utilization and timing analysis.
منابع مشابه
Design and Implementation of MIMO-OFDM us-ing Encoding and Decoding techniques on FPGA
In this paper, we present a memory-efficient and faster convolution encoding and adaptive viterbi decoding implementation technique for MIMO-OFDM communication systems on FPGA. A method for the 1/3 convloution encoder and Modified viterbi decoder design used for coding techniques on FPGA. Our design utilizes the minimum required on-chip memory for the MIMO-OFDM implementation. Using the propose...
متن کاملVLSI Implementation of a 2x2 MIMO-OFDM System on FPGA
-Multiple Input Multiple Output Orthogonal Frequency Division Multiplexing (MIMO-OFDM) technology is an attractive transmission technique for wireless communication systems with multiple antennas at transmitter and receiver. The core of this technology is that it divides one data stream to many. Hence, data rate, reliability and diversity can be increased along with the stability for multipath ...
متن کاملEfficient FPGA-based Implementations of the MIMO-OFDM Physical Layer
In this paper, we present a prototype FPGA design for an efficient physical layer implementation of a MIMO-OFDM technique. We propose a pipelined architecture using a Fast Fourier Transform that is shared across modulations for the system. Our experimental results show that the proposed implementation saves at least 30 percent of the hardware resources, while achieving the same data rate as kno...
متن کاملDesign Fpga Implementation of 4×4 Mimo Ofdm Transceiver Using System Generator
Orthogonal Frequency Division Multiplexing (OFDM) is the most widely used modulation technique for wireless communication network. In this paper, 4 x 4 spatially multiplexed MIMO OFDM transceiver is designed using 1/2 encoder and 64 bit FFT. The implementation has been carried out in hardware using Field Programmable Gate Array (FPGA). Both the transmitter and the receiver are implemented on a ...
متن کاملSystem-level characterization of a real-time 4×4 MIMO-OFDM transceiver on FPGA
The performance of an FPGA-based MIMO-OFDM testbed is investigated through measurements. The setup includes two real-time terminals, supporting up to 4 spatial streams, and a wideband multipath channel emulator. The performance of the system, transmitting at data rates up to 216Mbit/s over a 20MHz channel in the 2.4GHz ISM band, is benchmarked under different channel scenarios. The impact of di...
متن کامل