Dopant Distribution in Atomic Layer Deposited ZnO:Al Films Visualized by Transmission Electron Microscopy and Atom Probe Tomography
نویسندگان
چکیده
The maximum conductivity achievable in Al-doped ZnO thin films prepared by atomic layer deposition (ALD) is limited by the low doping efficiency of Al. To better understand the limiting factors for the doping efficiency, the three-dimensional distribution of Al atoms in the ZnO host material matrix has been examined on the atomic scale using a combination of high-resolution transmission electron microscopy (TEM) and atom probe tomography (APT). Although the Al distribution in ZnO films prepared by so-called "ALD supercycles" is often presented as atomically flat δ-doped layers, in reality a broadening of the Al-dopant layers is observed with a full-width-half-maximum of ∼2 nm. In addition, an enrichment of the Al at grain boundaries is observed. The low doping efficiency for local Al densities > ∼1 nm-3 can be ascribed to the Al solubility limit in ZnO and to the suppression of the ionization of Al dopants from adjacent Al donors.
منابع مشابه
Physical and electrical properties of MOCVD and ALD deposited HfZrO4 gate dielectrics for 32nm CMOS high performance logic SOI technologies
The physical properties of metal-organic chemical vapor deposition (MOCVD) and atomic layer deposition (ALD) deposited HfZrO4 films have been analyzed in detail by atom probe tomography, X-ray photoelectron spectroscopy, Rutherford backscattering spectrometry, transmission electron microscopy, atomic force microscopy, variable angle spectroscopic ellipsometry as well as temperature dependent gr...
متن کاملEffect of the Milling Time of the Precursors on the Physical Properties of Sprayed Aluminum-Doped Zinc Oxide (ZnO:Al) Thin Films
Aluminum doped zinc oxide (ZnO:Al) thin films were deposited on soda-lime glass substrates by the chemical spray technique. The atomization of the solution was carried out by ultrasonic excitation. Six different starting solutions from both unmilled and milled Zn and Al precursors, dissolved in a mix of methanol and acetic acid, were prepared. The milling process was carried out using a planeta...
متن کاملStudy of Microstructure and Elemental Micro-Composition of ZnO:Al Thin Films by Scanning and High Resolution Transmission Electron Microscopy and Energy Dispersive X-Ray Spectroscopy
The microstructure and micro-composition of ZnO thin films doped with Al, deposited on Si/SiO2 substrates by sol-gel method were investigated by scanning and high resolution transmission electron microscopy and related energy dispersive X-ray analyses (SEM-EDX, STEM-HRTEM/EDX). Thin films of ZnO were prepared by deposition of 1-10 successive layers with 0.5 at.% and 5 at.% Al concentrations. Th...
متن کاملTin Oxide Thin Films Grown on the (1̄012) Sapphire Substrate
Tin oxide thin films were deposited on the R-cut sapphire substrate by the electron-beam evaporation of a ceramic SnO2 source. X-ray diffraction and transmission electron microscopy studies revealed that the films deposited at lower temperatures were amorphous while those grown at temperatures above 350◦C consisted of the α-SnO phase with the PbO type structure. Epitaxial α-SnO films on the R-c...
متن کاملBand-Gap Tuning Of Electron Beam Evaporated Cds Thin Films
The effect of evaporation rate on structural, morphological and optical properties of electron beam evaporated CdS thin films have been investigated. CdS thin film deposited by electron beam evaporation method in 12nm/min and 60nm/min evaporation rates on glass substrates. X-ray diffraction, scanning electron microscopy, UV-Vis-NIR spectroscopy and Atomic Force Microscopy were used to character...
متن کامل