RFC 5467 Asymmetric Bandwidth Bidirectional LSP
نویسنده
چکیده
This document defines a method for the support of GMPLS asymmetric bandwidth bidirectional Label Switched Paths (LSPs). The presented approach is applicable to any switching technology and builds on the original Resource Reservation Protocol (RSVP) model for the transport of traffic-related parameters. The procedures described in this document are experimental. Table of
منابع مشابه
Engineering Task Force ( IETF ) A . Takacs
This document defines a method for the support of GMPLS asymmetric bandwidth bidirectional Label Switched Paths (LSPs). The approach presented is applicable to any switching technology and builds on the original Resource Reservation Protocol (RSVP) model for the transport of traffic-related parameters. This document moves the experiment documented in RFC 5467 to the standards track and obsolete...
متن کاملDefinition of Time to Live TLV for LSP-Ping Mechanisms
LSP-Ping is a widely deployed Operation, Administration, and Maintenance (OAM) mechanism in MPLS networks. However, in the present form, this mechanism is inadequate to verify connectivity of a segment of a Multi-Segment Pseudowire (MS-PW) and/or bidirectional co-routed Label Switched Path (LSP) from any node on the path of the MS-PW and/or bidirectional co-routed LSP. This document defines a T...
متن کاملRFC 3214 LSP Modification Using CR - LDP
This document presents an approach to modify the bandwidth and possibly other parameters of an established CR-LSP (Constraint-based Routed Label Switched Paths) using CR-LDP (Constraint-based Routed Label Distribution Protocol) without service interruption. After a CR-LSP is set up, its bandwidth reservation may need to be changed by the network operator, due to the new requirements for the tra...
متن کاملBidirectional Forwarding Detection (BFD) for MPLS Label Switched Paths (LSPs)
One desirable application of Bidirectional Forwarding Detection (BFD) is to detect a Multiprotocol Label Switching (MPLS) Label Switched Path (LSP) data plane failure. LSP Ping is an existing mechanism for detecting MPLS data plane failures and for verifying the MPLS LSP data plane against the control plane. BFD can be used for the former, but not for the latter. However, the control plane proc...
متن کاملMultipoint LDP (mLDP) In-Band Signaling with Wildcards
There are scenarios in which an IP multicast tree traverses an MPLS domain. In these scenarios, it can be desirable to convert the IP multicast tree "seamlessly" into an MPLS Multipoint Label Switched Path (MP-LSP) when it enters the MPLS domain, and then to convert it back to an IP multicast tree when it exits the MPLS domain. Previous documents specify procedures that allow certain kinds of I...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2009