Calibration of the Beam-Position Monitor System for the SLAC PEP-II B Factory

The Beam-Position Monitors (BPM) for the PEP-II B Factory consist of four 1.5cm diameter button style pickups mounted on the diagonals of the quadrupole vacuum chambers. Before installation of the vacuum chambers in the quadrupole assemblies, the electrical center of the BPMs is measured with respect to the mechanical center in a calibration test stand. In this paper the calibrations test stand is described and the precision and accuracy of the calibrations are presented. After installation of the quadrupole assemblies in the PEP-II tunnel, the passive attenuation for each channel of the system is measured to preserve the accuracy of the calibration. Finally, the active electronics includes an on-board calibrator. Results for these portions of the calibration are presented. Submitted to the 1997 Particle Accelerator Conference, 12-16 May 1997, Vancouver, B.C., Canada * Work supported by Department of Energy contract DE–AC03–76SF00515 (SLAC), W-7405-Eng-48 (LLNL), and DE-AC03-76SF00098 (LBNL). CALIBRATION OF THE BEAM-POSITION MONITOR SYSTEM FOR THE SLAC PEP-II B FACTORY R. Johnson, S. Smith, N. Kurita, SLAC, Stanford, CA 94309; K. Kishiyama, LLNL, Livermore, CA 94550; and J. Hinkson, LBNL, Berkeley, CA 94720