MEASUREMENT OF ANALOG SIGNALS BY MEANS OF THE IEEE Std 1149.4 MIXED-SIGNAL TEST BUS
نویسندگان
چکیده
Architecture and properties of the virtual probes created by the analog modules of the IEEE Std 1149.4 test bus are presented. Capabilities of the bus co-operated with the CIM 97 Multidiatest Measurement System in the area of the analog signal were investigated on the examples of the resistance, capacitance and inductance measurement. Application of the bus, when access to analog nodes of the circuits is limited and the analytical method is needed for supporting of testing, is discussed.
منابع مشابه
IEEE 1149.4 Analog and Mixed-Signal Test Bus Standard
The Analog and Mixed-Signal Boundary-Scan Standard (IEEE1149.4 hereafter referred as dot4) was developed to measure external discrete components in a mixed-signal Printed Circuit Assembly (PCA). This bus uses 4 of the same signals used today to support IEEE1149.1 compliant devices and systems. It uses two additional wires bus to perform analog monitoring and control. But testing a mixed-signal ...
متن کاملPreliminary Results of Passive Component Measurement Methods Using an IEEE 1149.4 Compliant Device
This paper demonstrates several methods of measurement of passive components using an IEEE 1149.4 compliant device and low cost laboratory measurement equipment. It will briefly describe the IEEE 1149.4 mixed signal test bus standard and its features, and it will describe the device that was used to prove its concepts of virtual probing, AC and DC measurements and data acquisition possibilities...
متن کاملMethods to test discrete semiconductors in 1149.4 environment
—This paper describes methods of testing discrete semiconductors in the environment defined by the IEEE 1149.4 standard for a mixed-signal bus. First, measurement procedures for obtaining central electrical parameters of diodes and transistors are introduced and illustrated. Then, the procedures are carried out and the achieved measurement results presented. It was found that testing and measur...
متن کاملChapter 6.2 Dft Techniques for Mixed-signal Integrated Circuits
This chapter presents several design methods that can be used to improve the testability of mixed-signal integrated circuits. This work will begin by outlining the importance of test and its impact on product cost and quality. Following this, we will look at the impact of manufacturing defects on the functional behavior of analog and digital circuits. Subsequently, we shall outline several comm...
متن کاملAn On-Chip Analog Mixed-Signal Testing Compliant with IEEE 1149.4 Standard Using Fault Signature Characterization Technique 85 An On-Chip Analog Mixed-Signal Testing Compliant with IEEE 1149.4 Standard Using Fault Signature Characterization Technique
An on-chip analog mixed-signal testing, compliant with IEEE 1149.4 standard is presented. The testing technique is based on sinusoidal output response characterizations, yielding a complete detection of AC and DC fault signatures without a need for simulation-before-test process. The testing system is an extension of IEEE 1149.4 standard, and affords functionalities for both pre-screening on-ch...
متن کامل