RFC 5818 Data Channel Statuses and LMP April 2010
نویسندگان
چکیده
This document defines simple additions to the Link Management Protocol (LMP) to provide a control plane tool that can assist in the location of stranded resources by allowing adjacent Label-Switching Routers (LSRs) to confirm data channel statuses and provide triggers for notifying the management plane if any discrepancies are found. As LMP is already used to verify data plane connectivity, it is considered to be an appropriate candidate to support this feature.
منابع مشابه
RFC 5818 Data Channel Statuses and LMP April
This document defines simple additions to the Link Management Protocol (LMP) to provide a control plane tool that can assist in the location of stranded resources by allowing adjacent Label-Switching Routers (LSRs) to confirm data channel statuses and provide triggers for notifying the management plane if any discrepancies are found. As LMP is already used to verify data plane connectivity, it ...
متن کاملLink Management Protocol (LMP)
Future optical networks will consist of photonic switches, optical crossconnects, and routers that may be configured with links consisting of a number of user bearer channels and an associated control channel. This paper describes a new link management protocol, called LMP, which runs between neighboring nodes and will be used for both link provisioning and fault isolation. A unique feature of ...
متن کاملRFC 4631 LMP - MIB Module September
This document provides minor corrections to and obsoletes RFC 4327. This memo defines a portion of the Management Information Base (MIB) for use with network management protocols in the Internet community. In particular, it describes managed objects for modeling the Link Management Protocol (LMP). Dubuc, et al. Standards Track [Page 1] RFC 4631 LMP-MIB Module September 2006
متن کاملA Transport Network View of the Link Management Protocol (LMP)
The Link Management Protocol (LMP) has been developed as part of the Generalized MPLS (GMPLS) protocol suite to manage Traffic Engineering (TE) resources and links. The GMPLS control plane (routing and signaling) uses TE links for establishing Label Switched Paths (LSPs). This memo describes the relationship of the LMP procedures to ’discovery’ as defined in the International Telecommunication ...
متن کاملLink Management Protocol (LMP) for Dense Wavelength Division Multiplexing (DWDM) Optical Line Systems
Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Abstract The Link Management Protocol (LM...
متن کامل