Strength, deformation and relaxation of joints bonded with modified cyanoacrylate adhesives
نویسنده
چکیده
The introduction of high molecular weight poly(methyI methacrylate) or poly(butadiene-co-acrylonitrile) into ethyl 2-cyanoacrylate produced viscous adhesives with a homogeneous or heterogeneous structure after cure. Steel joints bonded with these adhesives are shown to have improved tensile shear strength, deformability and stress relaxation of bonds compared with pure cyanoacrylate adhesive. Poly(methyl methacrylate)-modified adhesive is recommended for static load-bearing joints while poly(butadiene-co-acrylonitrile)-modified adhesive is more suited to cyclic or vibrating loads.
منابع مشابه
Shear bond strength evaluation of resin composite to resin-modified glass-ionomer cement using three different resin adhesives vs. glass-ionomer based adhesive
Background: The clinical success of sandwich technique depends on the strength of resin-modified glass ionomer cement (RMGIC) bonding to both dentin and resin composite. Therefore, the shear bond strength (SBS) of resin composite bonded to RMGIC utilizing different resin adhesives versus a GIC-based adhesive was compared. Materials and methods: In this in vitro study, 84 holes (5×2 mm) were pre...
متن کاملShear Bond Strength of Metallic and Ceramic Brackets Bonded with Two-step and Three-step Light Cure Adhesives
Background and purpose: The bonding process is highly important in orthodontic treatment for its fast speed. The purpose of this study was to compare the shear bond strength of ceramic and metallic brackets between three stage (transbondTM XT) and two stage (GC ortho connectTM) light cure composites. Materials and methods: In this experimental study, 80 maxillary and mandibular first and sec...
متن کاملComparison of shear bond strength of stainless steel brackets bonded with three light- cured adhesives
Introduction: The bonding process of the brackets to enamel has been a critical issue in orthodontic research. The purpose of this study was to evaluate the shear bond strength of 3 light-cured adhesives (transbond XT, Z250, light bond). Materials &Methods: In this study sixty extracted human premolars were collected and randomly divided into 3 test groups. All teeth were etched by 37% phosp...
متن کاملAnalytical and Experimental Studies on Stress Capacity with Modified Wood Members under Combined Stresses
The stress capacity of joints made of modified wood members under loading can be affected by design of joints and type of adhesive. Hence, these factors were addressed in this study by assessment of stress capacity variations in corner joints under diagonal applied compressive load induced combined stresses. The joints with mitered and butted design were constructed by application of epoxy and ...
متن کاملViscoelastic analysis of stress distribution in balanced and unbalanced adhesively bonded single-lap joints with functionally graded adherends under the Reddy model
In this study, shear and peel stress distributions in the viscoelastic adhesive layer of a single-lap joint (SLJ) with functionally graded (FG) adherends are investigated. The study focuses on the effect of different adherend profiles and material composition on the time-dependent stress concentration/distribution in balanced and unbalanced SLJs. For this purpose, the Reddy model is applied to ...
متن کامل