Design of Single Input Multiple Output DC-DC Converter
نویسنده
چکیده
This paper proposes a design of single input multiple output (SIMO) dc–dc converter. The proposed converter can generate the voltage of a low voltage input to controllable levels of boosted output voltage and it can also produce the inverted output voltage. This dc-dc converter utilizes the properties of voltage clamping and soft switching based on a coupled inductor. In this paper, the design of SIMO dc-dc converter along with modes of operation has been presented using MATLAB / SIMULINK. Simulation results thus obtained show that, the objectives of high-efficiency, high step up ratio and various levels of output voltages. Keywords— Coupled inductor, single-input multiple-output (SIMO) converter, soft switching, voltage clamping.
منابع مشابه
Implementation of Floating Output Interleaved Input DC-DC Boost Converter
This paper presents the analysin ,design and implementation of a high voltage ratio topology of DC-DC converter. The DC-DC converter has high voltage ratio with reduced input current, output voltage and output current ripple, and also reduces the voltage and current rating of power electronics components and compared with conventional boost converter. The voltage stress on the switches are red...
متن کاملDesign and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter
A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...
متن کاملOn-grid and Off-grid Operation of Multi-Input Single-Output DC/DC Converter based Fuel Cell Generation System
This paper presents the modeling and simulation of a proton exchange membrane fuel cell (PEMFC) generation system for off-grid and on-grid operation and configuration. A fuel cell DG system consists of a fuel cell power plant, a DC/DC converter and a DC/AC inverter. The dynamic model for fuel cell array and its power electronic interfacing are presented also a multi-input single output (MISO) D...
متن کاملAnalysis and Design of a New Single Switch Non-Isolated Buck-Boost dc-dc Converter
In this paper, a new transformerless buck-boost converter based on ZETA converter is introduced. The proposed converter has the ZETA converter advantages such as, buck-boost capability and input to output DC insulation. The suggested converter voltage gain is higher than the classic ZETA converter. In the presented converter, only one main switch is utilized. The proposed converter offers low v...
متن کاملDevelopment of Average Model for Control of a Full Bridge PWM DC-DC Converter
This paper presents a detailed small-signal and transient analysis of a full bridge PWM DC-DC converter designed for high voltage, high power applications using an average model. The derived model is implemented in a typical system and used to produce the small-signal and transient characteristics of the converter. Results obtained in the analysis of the high voltage and high power design examp...
متن کامل