25.2 A 2.2GHz -242dB-FOM 4.2mW ADC-PLL using digital sub-sampling architecture

نویسندگان

  • Teerachot Siriburanon
  • Satoshi Kondo
  • Kento Kimura
  • Tomohiro Ueno
  • Satoshi Kawashima
  • Tohru Kaneko
  • Wei Deng
  • Masaya Miyahara
  • Kenichi Okada
  • Akira Matsuzawa
چکیده

This paper presents an all-digital phase-locked loop (PLL) using a voltage-domain digitization realized by an analog-to-digital converter (ADC). It consists of an 18b Class-C digitally-controlled oscillator (DCO), 4b comparator, digital loop filter (DLF), and frequency-locked loop (FLL). Implemented in 65nm CMOS technology, the proposed PLL reaches an in-band phase noise of -112dBc/Hz and an RMS jitter of 380fs at 2.2GHz oscillation frequency. An FOM of -242dB has been achieved with a power consumption of only 4.2 mW.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Submission Format for IMS2004 (Title in 18-point Times font)

In a classical PLL, the phase detector (PD) and charge pump (CP) noise is multiplied by N, when referred to the VCO output, due to the divide-by-N in the feedback path. It often dominates the in-band phase noise and limits the achievable PLL jitter·power Figure-Of-Merit (FOM). A subsampling PLL uses a PD that sub-samples the high frequency VCO output with the reference clock. The PD and CP nois...

متن کامل

A 2.2GHz 7.6mW sub-sampling PLL with -126dBc/Hz in-band phase noise and 0.15psrms jitter in 0.18µm CMOS

A clock with low phase-noise/jitter is a prerequisite for high-performance ADCs, wireline and optical data links and radio transceivers. This paper presents a 2.2GHz clock-generation PLL. It uses a phase-detector/charge-pump (PD/CP) that sub-samples the VCO output with the reference clock. The PLL does not need frequency divider in locked state and achieves a low in-band phase noise values at l...

متن کامل

Session 4 - Frequency and phase generation techniques

In a classical PLL, the phase detector (PD) and charge pump (CP) noise is multiplied by N, when referred to the VCO output, due to the divide-by-N in the feedback path. It often dominates the in-band phase noise and limits the achievable PLL jitter•power Figure-Of-Merit (FOM). A sub-sampling PLL uses a PD that sub-samples the high frequency VCO output with the reference clock. The PD and CP noi...

متن کامل

A 500-MS/s, 2.0-mW, 8-Bit Subranging ADC with Time-Domain Quantizer

This paper describes a novel energy-efficient, high-speed ADC architecture combining a flash ADC and a TDC. A high conversion rate can be obtained owing to the flash coarse ADC, and low-power dissipation can be attained using the TDC as a fine ADC. Moreover, a capacitive coupled ramp circuit is proposed to achieve high linearity. A test chip was fabricated using 65-nm digital CMOS technology. T...

متن کامل

Sampling Phase Detection

In PLL designs, a wide loop bandwidth is often desired as it offers fast settling time, reduces on-chip loop filter area and sensitivity of the VCO to pulling. The reference spur is a major issue when the bandwidth is increased, because ripples on the VCO control line undergo less filtering by the loop filter. This paper proposes design techniques based on sub-sampling phase detection to reduce...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2015