Temperature determination from the lattice gas model.

نویسندگان

  • Das Gupta S
  • Pan
  • Tsang
چکیده

Determination of temperature from experimental data has become important in searches for critical phenomena in heavy ion collisions. Widely used methods are ratios of isotopes (which rely on chemical and thermal equilibrium), population ratios of excited states etc. Using the lattice gas model we propose a new observable: nch/Z where nch is the charge multiplicity and Z is the charge of the fragmenting system. We show that the reduced multiplicity is a good measure of the average temperature of the fragmenting system. PACS Number: 21.60.-n, 21.10.-k Typeset using REVTEX

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Numerical simulation of a three-layered radiant porous heat exchanger including lattice Boltzmann simulation of fluid flow

This paper deals with the hydrodynamic and thermal analysis of a new type of porous heat exchanger (PHE). This system operates based on energy conversion between gas enthalpy and thermal radiation. The proposed PHE has one high temperature (HT) and two heat recovery (HR1 and HR2) sections. In HT section, the enthalpy of flowing high temperature gas flow that is converted to thermal radiation em...

متن کامل

Temperature Distribution of a Non gray Gas between Two Parallel Planes Using Exponential Wide Band Model

In this paper, the Radiation Transfer Equation(RTE) for a non-gray gas between two large parallel planes has been solved and the temperature distribution obtained. With the RTE, solution heat fluxes are also determined. Since and are two components of most combustion products, the problem has been solved for these two gases. The results were, whenever possible, compared with data reported el...

متن کامل

Lattice Boltzmann modeling of two component gas diffusion in solid oxide fuel cell

In recent years, the need for high efficiency and low emission power generation systems has made much attention to the use of fuel cell technology. The solid oxide fuel cells due to their high operating temperature (800 ℃ -1000 ℃) are suitable for power generation systems.Two-component gas flow (H2 and H2O) in the porous media of solid oxide fuel cell’s anode have been modeled via lattice Boltz...

متن کامل

Data Envelopment Analysis from simulation on the Lattice QCD using CCR model

One of the most serious principles in production theory in economic is the principle of "efficiency". Simply put, efficiency can be defined as the demand that the desired goals (outputs) are achieved with the minimum use of the available resources (inputs). In order to, distinguish the relative efficiency of organizational units with multiple inputs to produce multiple outputs, "Data Envelopmen...

متن کامل

Developing a Novel Temperature Model in Gas Lifted Wells to Enhance the Gas Lift Design

In the continuous gas lift operation, compressed gas is injected into the lower section of tubing through annulus. The produced liquid flow rate is a function of gas injection rate and injection depth. All the equations to determine depth of injection assumes constant density for gas based on an average temperature of surface and bottomhole that decreases the accuracy of gas lift design. Also g...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Physical review. C, Nuclear physics

دوره 54 6  شماره 

صفحات  -

تاریخ انتشار 1996