On the analysis of accumulation curves.
نویسندگان
چکیده
Identifying and counting the total number of biological species observed, when plotted against a measure of the effort used to record them, gives rise to a species accumulation curve. We investigate estimation of the total number of species and other relevant properties of accumulation by elaborating on the multinomial model (Nakamura and Peraza, 1998, Journal of Agricultural, Biological, and Environmental Statistics, 3, 17-36) that includes specification of a beta density for recording probabilities. We consider a unified description including complete and incomplete (aggregated) curves, a more general scheme for recording, and a Bayesian framework to allow for inclusion of the biologist's knowledge with regard to typical recording probabilities and the total number of species. The beta distribution is used as a prior, but recording probabilities are not restrained to be beta distributed. The methods yield either closed analytical expressions for inference or relatively simple numerical procedures. Predictive distributions of future recordings that would eventually lead to an optimal decision-theoretical rule for stopping collection effort may be easily calculated. A case study regarding species of bats is considered, including some guidelines for elicitation of an informative prior.
منابع مشابه
Experimental investigations on the softening and ratcheting behaviors of steel cylindrical shell under cyclic axial loading
In this research, softening and ratcheting behaviors of Ck20 alloy steel cylindrical shells were studied under displacement-control and force-control cyclic axial loading and the behavior of hysteresis curves of specimens was also investigated. Experimental tests were performed by a servo-hydraulic INSTRON 8802 machine. The mechanical properties of specimens were determined according to ASTM E8...
متن کاملInvestigation of purge time in cathodic dead-end mode PEMFC
Recently, special type of fuel cells has been developed that operates in a Dead End mode. Working in this condition, the Dead-End fuel cell is supplied withhydrogen almost at the same rate of consumption. It is noteworthy to mention thatall of the water transport mechanisms have been considered in this simulation.Water accumulation that is directly proportional to the cell current is of a grea...
متن کاملA new approach to define batch settling curves for analyzing the sedimentation characteristics
The results of batch settling tests (BST) are used to investigate settling behavior of solids suspension, which contribute to sizing thickeners. Conventional methods in analyzing BST on the basis of visual and graphical procedures lead to sub-optimally sized and selected thickeners. A computational approach based on quantitative analysis of BST can be beneficial. About 300 settling experiments ...
متن کاملGeohistory Analysis of the Tabas Block (Abdoughi-Parvadeh Basins) as Seen from the Late Triassic through Early Cretaceous Subsidence Curves
The study area is situated in the Middle part of the Tabas Block. It contains outcrops of rocks that formed along longitudinal faults in Early Cimmerian orogenic phase. The basin subsided along these faults from the Late Triassic to Early Cretaceous, which include two sedimentary cycles. A sedimentary cycle, related to Upper Triassic to Bajocian is known as Shemshak group. Another sedimentary c...
متن کاملFragility Curves for Reinforced Concrete Frames with Lap-Spliced Columns
Placing column lap-splice in the locations of possible nonlinear deformation may adversely affect the structures response to strong ground motions. Localization of damage in splice zone may change the structural response and prevent the load redistribution and development of a uniform pattern of nonlinear excursions among the various members. Validated by existing laboratory experiments, this s...
متن کاملon the Elastic Stability of Sleeve Stiffened Hollow Columns; Focusing on Determination of Optimal Design Curves (TECHNICAL NOTE)
The stability analysis of sleeve stiffened pin-ended slender hollow columns of pipe or box section is performed in the present study. This is accomplished by using energy method, employing three terms in the assumed approximate deflection function. The lengthy and tedious algebraic manipulations involved in solving the relevant eigenvalue problem, necessitates employing the "MATHEMATICA" softwa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Biometrics
دوره 56 3 شماره
صفحات -
تاریخ انتشار 2000