Lna and Rf Vga for Broadband and Wide Dynamic Range Dvb-s2 Receiver Tuner in 0.18 Μm Cmos Process

نویسنده

  • Bhanu Shrestha
چکیده

We present a design of broadband and wide dynamic range low noise amplifier/radio frequency variable gain amplifier (LNA/RF VGA) for digital video broadcasting – satellite (DVBS2) receiver tuner integrated circuit fabricated using the 0.18 μm complementary metal oxide semiconductor (CMOS) process. The MOS switching filter was used to get broadband characteristics of the LNA circuit and the MOS channel resistance with two attenuators was used to obtain a wide dynamic range characteristic of the RF VGA. The LNA/RF VGA block achieved a gain control range of 50 dB, IIP3 of +15 dBm at low gain mode and a noise figure of 6.3 dB at the frequency range of 950 MHz ~ 2150 MHz. The RF VGA circuit consumed a total current of 28 mA with the supply voltage of 1.8 V and the chip area was 1.4 mm × 0.6 mm including I/O pads.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

An inductorless wideband noise-cancelling CMOS low noise amplifier with variable-gain technique for DTV tuner application

In this paper, we propose an inductorless CMOS wideband low noise amplifier (LNA), operated in the range from 100 to 900MHz, with current reuse, mirror bias, gain control and input matching device using noise-cancellation technologies. The traditional wideband LNAs have different input reflection coefficient parameters (S11) at different gain control modes, and they always implement with induct...

متن کامل

A Low Noise Amplifier Optimized for a GPS Receiver RF Front End

A cascode LNA was optimized for a GPS receiver radio frequency front end using a 0.18 μm CMOS technology. By careful choice of device geometry, gate and source degeneration inductors, a fully integrated LNA can be optimized to have a low noise figure, a high voltage gain and a wide dynamic range. The optimized LNA has a 1.512 dB noise figure, a –42.05 dB S11, a 20.04 dB voltage gain a –19.82 dB...

متن کامل

RF front - end design for terrestrial and mobile digital television systems ( May 2007 )

CMOS RF front-end design for terrestrial and mobile digital television systems (May 2007) Jianhong Xiao Chair of Advisory Committee: Jose Silva-Martinez With the increasing demand for high quality TV service, digital television (DTV) is replacing the conventional analog television. DTV tuner is one of the most critical blocks of the DTV receiver system; it down-converts the desired DTV RF chann...

متن کامل

A 0.18-μm 2.4~6GHz CMOS Broa For WLAN and UW

A 2.4-6 GHz broadband CMOS differential LNA for WLAN and UWB receiver is presented. The LNA is fabricated with the 0.18 μm 1P6M standard CMOS process. Measurement of the chip is performed on a FR-4 PCB test fixture. In the UWB low-band (3 to 5.15GHz), the broadband LNA exhibit a gain of 17.5-18.2 dB, noise figure of 3.4-5dB, input/output return loss better than 10 dB, and input P1dB of –17 dBm,...

متن کامل

Design Analysis and Comparative Study of Rf Receiver Front-ends in 0.18-μm Cmos

In this work, design and simulation results of two RF front-ends to be used in direct conversion receiver are presented. The first one uses dual CS differential LNA with folded mixer. The second one uses single-ended LNA with double balanced mixer. Single-ended and fully differential LNA’s provide gains of 16.3 dB and 28.75 dB at 2.4GHz, respectively. Noise Figure of these two LNA’s are 3.34 dB...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2010