Nitritation and N2O Emission in a Denitrification and Nitrification Two-Sludge System Treating High Ammonium Containing Wastewater

The effective management of high ammonium containing wastewater is important for the sustainable development of the wastewater industry. A pre-denitrification and post-nitrification two-sludge system was proposed to treat high ammonium containing wastewater with low carbon-to-nitrogen (C/N) ratios. In the system, pre-denitrification was adopted to use organic carbon in raw wastewater efficiently for nitrogen removal, while post-nitrification was adopted to achieve nitritation. System performance and the characteristics of nitrous oxide (N2O) emission were examined. As to the influent chemical oxygen demand (COD) and ammonium nitrogen (NH4-N) concentration, both 800 mg/L, nitrogen removal was mainly through pre-denitrification, and the nitrogen removal percentage was 43.4%. In post-nitrification, nitritation was achieved with a nitrite accumulation efficiency of 97.8% and a NH4-N removal loading rate of 0.45 g/(L·d). With nitrite as the electron acceptor during denitrification, its removal rate increased, while the N2O emission factor decreased with increasing C/N ratios. Nitrification was affected significantly by the aeration rate. When the aeration rate was below 0.6 L/min, the NH4-N removal rate increased, while the N2O emission rate decreased with increasing aeration rates. However, when the aeration rate was above 0.6 L/min, it had little influence on N2O OPEN ACCESS