Ignition of hydraulic fluid sprays by open flames and hot surfaces

نویسنده

  • Liming Yuan
چکیده

A study of the ignition of non-fire-resistant hydraulic fluid sprays was conducted by the National Institute for Occupational Safety and Health. Both an open flame and a hot steel surface were used as the external heat sources. With the open flame as the heat source, the minimum oil temperature and minimum spray nozzle pressure that resulted in an ignition were measured. The effects of the distance between the open flame and the nozzle and the nozzle orifice diameter on the ignitability of the hydraulic fluid sprays were examined. With the hot surface as the heat source, the minimum surface ignition temperature was determined. The degree of oil atomization and the relative direction of oil injection with respect to the hot surface are discussed. The ignition of oil sprays from the impingement of oil jets onto a vertical surface was also investigated. Finally, the results are compared with those obtained for fire-resistant hydraulic fluids.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Combustion kinetics

Combustion kinetics ...................................................................................................................................... 1 Physical mixing and its effects on ignition, propagation and extinction ...................................................... 2 Mixing ...........................................................................................................

متن کامل

Stability and Liftoff of Non-premixed Large Hydrocarbon Flames in MILD Conditions

The Moderate or Intense Low-oxygen Dilution (MILD) combustion regime has received interest from the industrial furnace and gas turbine engine industries due to attractive properties of reduced NOx emissions and high thermal efficiency. MILD combustion is characterized by low oxygen concentrations (i.e. 3-9% by volume) and high reactant temperatures. The focus of the current study was to underst...

متن کامل

Cyclic flame propagation in premixed combustion

In experiments of hot surface ignition and subsequent flame propagation, a puffing flame instability is observed in mixtures that are stagnant and premixed prior to ignition. By varying the size of the hot surface, power input, and combustion vessel volume, it was determined that the instability is a function of the interaction of the flame, with the fluid flow induced by the combustion product...

متن کامل

Ignition and Flame Propagation in Dilute Polydisperse Sprays ; Importance of d 32 and <

Suitability of the Sauter mean diameter and the surface-area mean diameter for representing the ignition and combustor behavior of polydisperse sprays is examined. Initial size distributions considered are the Nukiyama-Tanasawa distribution and a bidisperse spray. Two physical situations are analyzed. In the first, the ignition characteristics of a polydisperse spray in the viscinity of a hot w...

متن کامل

ABSTRACT Title of Thesis: CHARACTERIZING CIGARETTE LIGHTER FLAMES TO REDUCE UNWANTED IGNITION

Title of Thesis: CHARACTERIZING CIGARETTE LIGHTER FLAMES TO REDUCE UNWANTED IGNITION Justin Wade Williamson, Master of Sciences, 2003 Thesis Directed By: Professor André W. Marshall Department of Fire Protection Engineering This investigation provides detailed measurements and analysis for improved understanding of ignition from the ‘small’ flames produced by cigarette lighters. This research p...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2006