Microstructure Evolution and Shaping of Friction Stir Lap Welded Dissimilar Magnesium Alloy Joint
نویسندگان
چکیده
Friction stir lap welding (FSLW) experiment has been conducted on 3mm thick AZ80 extruded sheet and 2.3mm thick AZ31B rolled sheet. The influence of the shape of the taper thread mixing head on microstructure has been discussed. Pores forming, hooked defects, interface migration, tissue distribution have been analyzed. The organization of both sides of nugget zone (NZ) is arranged diagonally above, due to the corresponding resultant force along the thread of pin. NZ was collided to form a cascade "onion ring" by plastic microstructure rotating with thread of the pin and dropping from concave of mixing head conical body. Cavity defect was concerned with the poor deformation of AZ80 magnesium alloy placed underneath and relevant organization collision.
منابع مشابه
Forming and Properties of Friction Stir Welding Process for Dissimilar Mg Alloy
For hot extrusions of magnesium alloy sheets, Dissimilar AZ80 and AZ31 were used, in which AZ80 was placed on advancing side and AZ31 on retreating side, using friction stir butt welding with different process parameters. Some defect-free welded joints with good weld surfaces could be obtained with some suitable welding conditions. The maximum tensile strength of welded joint which is 225.5 MPa...
متن کاملFinite element simulation of microstructure evolution during friction stir welding of automotive aluminum parts
7000 series Aluminum alloys are widely used in the automotive industries for structural lightweight components due to their exceptional high strength to weight ratio. However, this class of aluminum alloy is difficult to join by conventional fusion welding techniques so Friction stir welding (FSW) widely is used for welding this alloys. The process has been demonstrated to be effective and is c...
متن کاملEvaluation of microstructure and mechanical properties of friction stir welded copper / 316L stainless steel dissimilar metals
In the present research, friction stir welding (FSW) process was used for butt joining of pure copper plate to 316L stainless steel plate. Mechanical properties and microstructural characteristics of the joint were evaluated by microhardness and tensile tests as well as optical and scanning electron microscope (SEM). It was found that microstructure of the weld nugget (WN) has fine grains where...
متن کاملReliability-Based Robust Multi-Objective Optimization of Friction Stir Welding Lap Joint AA1100 Plates
The current paper presents a robust optimum design of friction stir welding (FSW) lap joint AA1100 aluminum alloy sheets using Monte Carlo simulation, NSGA-II and neural network. First, to find the relation between the inputs and outputs a perceptron neural network model was obtained. In this way, results of thirty friction stir welding tests are used for training and testing the neural network...
متن کاملInvestigation of the effect of temperature on the corrosion behavior of welded joints similar of titanium alloy Ti-6Al-4V by friction stir welding method
In this study, corrosion behavior of Ti-6Al-4V titanium alloy joint by friction stir welding with a rotational speed of 375 rpm and a travel speed of 100 mm/min was investigated. The welding procedure was carried out under β-transus temperature that was consisted of equiaxed grains in the stir zone. The corrosion behavior of the welded joint was investigated in 3.5% NaCl solution at temperature...
متن کامل