3.2.4 Miscellaneous Methods for Measuring Matric or Water Potential
نویسندگان
چکیده
A variety of techniques to measure matric potential or water potential in the laboratory and in the field are described in this section. The techniques described herein require equilibration of some medium whose matric or water potential can be determined from previous calibration or can be measured directly. Under equilibrium conditions the matric or water potential of the medium is equal to that of the soil. The techniques can be divided into: (i) those that measure matric potential and (ii) those that measure water potential (sum of matric and osmotic potentials). Matric potential is determined when the sensor matrix is in direct contact with the soil, so salts are free to diffuse in or out of the sensor matrix, and the equilibrium measurement therefore reflects matric forces acting on the water. Water potential is determined when the sensor is separated from the soil by a vapor gap, so salts are not free to move in or out of the sensor, and the equilibrium measurement reflects the sum of the matric and osmotic forces acting on the water. Seven different techniques are described in this section. Those that measure matric potential include (i) heat dissipation sensors, (ii) electrical resistance sensors, (iii) frequency domain and time domain sensors, and (iv) electro-optical switches. A method that can be used to measure matric potential or water potential is the (v) filter paper method. Techniques that measure water potential include (vi) the Dew Point Potentiameter (Decagon Devices, Inc., Pullman, WA1) (water activity meter) and (vii) vapor equilibration. The first four techniques are electronically based methods for measuring matric potential. Heat dissipation sensors and electrical resistance sensors infer matric potential from previously determined calibration relations between sensor heat dissipation or electrical resistance and matric potential. Frequency-domain and timedomain matric potential sensors measure water content, which is related to matric potential of the sensor through calibration. Electro-optical switches measure changes in light transmission through thin, nylon filters as they absorb or desorb water in response to changes in matric potential. Heat dissipation sensors and electrical resistance sensors are used primarily in the field to provide information on matric potential. Frequency domain matric potential sensors are new and have not been widely used. Time domain matric potential sensors and electro-optical switches are
منابع مشابه
New Polymer Tensiometers: Measuring Matric Pressures Down to the Wilting Point
Tensiometers are commonly used for measuring soil water matric pressures. Unfortunately, the water-filled reservoir of conventional tensiometers limits their applicability to soil water matric pressures above approximately20.085 MPa. Tensiometers filled with a polymer solution instead of water are able to measure a larger range of soil water matric pressures. We designed and constructed six pro...
متن کاملOsmolyte dynamics and microbial communities vary in response to osmotic more than matric water deficit gradients in two soils
Sodium chloride and other osmotically active molecules are often applied to microbial cultures or soils to describe microbial responses and adaptation to desiccation in soils. However, salts and other osmolytes may have different effects on microorganisms than matric deficits caused by soil drying. It was thus hypothesized that low matric and osmotic potentials would have different effects on s...
متن کاملPii: S0022-1694(00)00198-0
The initial soil water content affects wetting front instability. A series of experiments were conducted where water was infiltrated into a 20/30 sand with initial volumetric water contents of 0, 0.005, 0.01, 0.015, 0.02, 0.03, 0.04 and 0.047 cm/cm. Both water content and matric potential were measured. Water content was measured with Synchrotron X-rays at the Cornell High Energy Synchrotron So...
متن کاملPrediction of the soil-water characteristic curve of dune sand stabilized with SBR polymer and MICP process in the Jabal Kandi area
Introduction The geotechnical engineering problems involving unsaturated soils are included water flow, shear strength and volume change. Soil-water characteristic curve (SWCC) describes the constitutive relationship between soil suction and soil water content. SWCC may be determined directly or indirectly in the laboratory. Because of the various difficulties involved in the direct measuremen...
متن کاملMatric potentials of leaves.
A pressure chamber was used to measure matric potentials of frozen and thawed leaves. Significant matric potentials were demonstrated in sunflower (Helianthus annuus L.), yew (Taxus cuspidata Sieb. and Zucc.), and rhododendron (Rhododendron roseum Rehd.). Matric potentials were particularly negative in rhododendron and were correlated with the amount of cell wall present and with the volume of ...
متن کامل