Residual stress evaluation in butt-welded steel plates
نویسندگان
چکیده
Faculty of Mechanical Engineering, Sardar Raja College of Engineering, Alangulam, Tirunelveli 627 808, India Faculty of Mechanical Engineering, Government College of Engineering, Tirunelveli 627 007, India Faculty of Mechanical Engineering, Alagappa Chettiar College of Engineering and Technology, Karaikudi 630 002, India Structural Analysis and Testing Group, Vikram Sarabhai Space Centre, Trivandrum 695 022, India
منابع مشابه
Acceptability of Residual Stresses Measurement Methods of Butt Weldments and Repairs
Original scientific paper The joints made by fusion of materials are exposed to the influence of residual stresses induced by welding thermal cycles. Residual stresses were measured on butt welded plates made of NIOMOL 490K, before and after reparation. The objective of this paper is to compare three methods of residual stress measurement (hole-drilling method, x-ray diffraction and directional...
متن کاملControl of Welding Residual Stress for Dissimilar Laser Welded Materials
The most common problem of welding dissimilar metals (DMWs) with respect to residual stresses is the differences in the coefficient of thermal expansion and heat conductivity of the two welded metals. In the present work, a CO2 continuous laser welding process was successfully applied and optimized for joining a dissimilar AISI 316 stainless steel and low carbon steel plates. The Taguchi approa...
متن کاملResidual Stresses in Butt and Socket Welded Joints
A finite element scheme for simulation of welding residual stresses is presented in this paper. Detailed thermal and residual stress analyses for butt-welded and socket-welded pipes are performed using ANSYS and ABAQUS. The calculated distribution of axial stress and hoop stress at welded joint are validated against experimental results. Furthermore, residual stress relaxation under high amplit...
متن کاملStress Relief and Material Properties Improvement Through Vibration VS. Common Thermal Method
The goal of this study is investigating reduction of residual stresses from welding carbon steel plates through vibrationstress reliefmethod vs. thermal method. In order to carry out the required experimental tests, carbon steel plates were welded together under specific conditions as samples. Some of the samples were vibration stress relieved, some were thermal stress relieved while the rest r...
متن کاملResidual Stress and Deformation Analysis in Butt Welding on 6 mm SUS304 Steel with Jig Constraints Using Gas Metal Arc Welding
This article proposes a novel method for analyzing residual stress and deformation in butt welding on 6 mm SUS304 stainless steel plates, using MSC.MARC, a commercial finite element method software, to find the best location for jig fixtures that will minimize welding deformation. Simulation and experimental studies show that a distance of 100 mm between the jig center and the welding bead cent...
متن کامل