Effect of low-frequency vibration on workpiece in EDM processes
نویسندگان
چکیده
High-frequency vibration aided EDM has become one of the ways to increase material removal rate in EDM process, due to the flushing effect caused by vibration. However, utilizing high-frequency vibration, especially in ultrasonic range consumes a lot of setup cost. This work presents an attempt to use a low-frequency vibration on workpiece of stainless steel (SS 304) during EDM process. The workpiece was vibrated with variations of low-frequency and low-amplitude. The results show that the application of low-frequency vibration in EDM process can be used to increase the material removal rate, and decrease the surface roughness and tool wear rate.
منابع مشابه
Effect of Electrical Discharge Machining on Stress Concentration in Titanium Alloy Holes
Titanium alloys have several advantages, such as a high strength-to-weight ratio. However, the machinability of titanium alloys is not as good as its mechanical properties. Many machining processes have been used to fabricate titanium alloys. Among these machining processes, electrical discharge machining (EDM) has the advantage of processing efficiency. EDM is based on thermoelectric energy be...
متن کاملPongamia pinnata Plant Seed Oil as Dielectric Fluid for Electro Discharge Machining Process
Electro Discharge Machining (EDM) is a noticeable machining practice among created unconventional machining procedures for intricate, complex profiles in "hard to machine" materials, similar to heat-treated steels, composites, superalloys, ceramics, composites, carbides, and so on. In EDM, the material expulsion of the cathode is accomplished through precise controlled electric discharge (the s...
متن کاملOptimisation of wire-cut EDM process parameter by Grey-based response surface methodology
Wire electric discharge machining (WEDM) is one of the advanced machining processes. Response surface methodology coupled with Grey relation analysis method has been proposed and used to optimise the machining parameters of WEDM. A face centred cubic design is used for conducting experiments on high speed steel (HSS) M2 grade workpiece material. The regression model of significant factors such ...
متن کاملAn Experimental Investigation on Surface Roughness and Edge Chipping in Micro Ultrasonic Machining
Surface quality including surface roughness and edge chipping is a key process measure in micro ultrasonic machining (Micro-USM) as an efficient process for micromachining of hard and brittle materials. Process parameters such as ultrasonic vibration amplitude, static load, type of tool material, type and size of abrasive particles and slurry concentration can influence the surface quality. How...
متن کاملDevelopment of a Vibration Device for Grinding with Microvibration
This study aimed to develop a device to facilitate grinding experiments with microvibration for analyzing the vibration effect on surface finish of ground surfaces. A microvibration device was designed and fabricated. It can be used to provide microvibration to the workpiece vertically and/or horizontally during grinding. The relationship of the driving voltage, vibration displacement, and freq...
متن کامل