Demonstration of a laserwire emittance scanner for the CERN LINAC4 H− Beam
نویسندگان
چکیده
T. Hofmann, ∗ K.O. Kruchinin, A. Bosco, S.M. Gibson, F. Roncarolo, G. Boorman, U. Raich, E. Bravin, J.K. Pozimski, A. Letchford, and C. Gabor Beam Instrumentation Group, CERN, CH-1211 Geneva 23, Switzerland John Adams Institute at Royal Holloway, University of London, Egham, TW20 0EX, United Kingdom Imperial College London, SW7 2AZ,United Kingdom STFC Rutherford Appleton Laboratory, Harwell Oxford, Didcot, OX11 0QX, United Kingdom. (Dated: November 5, 2015)
منابع مشابه
تطبیق پذیری باریکه -H در قسمت انرژی پایین و متوسط ماشین Linac4 در سرن
Linac4 is the near future 160 MeV H- linear accelerator of the CERN presently under construction. It will replace the present Linac2 as injector of the proton accelerator complex in CERN. The Linac4 is composed of a 45 keV ion source, a Low Energy Beam Transport (LEBT), a 352.2 MHz Radio Frequency Quadrupole (RFQ), which accelerates the beam to 3 MeV, and a Medium Energy Beam Transport (MEBT), ...
متن کاملDevelopment of beam transverse profile and emittance monitors for the CERN LINAC 4
LINAC4 is part of the CERN Large Hadron Collider injector chain upgrade (LIU) and will accelerate H− ions from 45 keV to 160 MeV, it will be the first step of the upgrade with the replacement of LINAC2 in 2018. In order to measure beam profiles along the LINAC, several SEM grid and wire beam scanner (WS) monitors will be installed between the RF cavities from 50 MeV to 160 MeV. This thesis cove...
متن کاملBeam Dynamics for a New 160 Mev H− Linac at Cern (linac4)
Linac4 is a normal conducting H_ linac proposed at CERN to provide a higher proton flux to the CERN accelerator chain. It should replace the existing Linac2 as injector for the PS booster (PSB). The same machine can also operate in the future as the front end of the SPL, a 2.2GeV superconducting linac with 1.8 mA average current. At present Linac4 consists of a Radio Frequency Quadrupole (RFQ),...
متن کاملRadiation Protection Study for the Shielding Design of the Linac4 Beam Dump at Cern
The aim of this study is to determine an optimal shielding of the LINAC4 beam dump fulfilling the radiation protection requirements. Therefore a detailed Monte-Carlo calculation using FLUKA particle transport and interaction code has been performed and the relevant physics quantities, such as particle fluences, neutron energy spectra, residual and prompt dose rates, air and water activation hav...
متن کاملTransverse emittance measurement devices for CERN injectors, present and future
The measurement of the transverse beam emittance is essential in any particle accelerator. This paper describes the problems of transverse emittance measurement for the new H LINAC being built at CERN as a replacement of the existing proton LINAC.
متن کامل