Modeling and characterization of all possible triple pass EDFA configurations
نویسندگان
چکیده
The main purpose of designing multi-stage erbium-doped fiber amplifiers (EDFAs) is to achieve higher gain and lower noise figure for long haul optical communication. Among the multi-stage EDFAs, triple pass EDFAs were chosen in this research. This paper presents all possible triple pass EDFA configurations. The well-established one-stage mathematical models were modified to design two-stage and three-stage triple pass EDFAs. Performances of all the configurations were analyzed with pump power ratio and signal power. Optimum length and Optimum pump power ratio were also determined for each and every configuration. From the performance analysis, best triple pass EDFA was recommended for practical design.
منابع مشابه
Erbium-Doped Fiber Amplifier Review
This paper is describing and investigating four crucial areas of Erbium Doped Fiber Amplifier (EDFA). First is the atomic part, where it is meaningful to give deep and details information of erbium spectra structure and its energy level. The atomic spectrum is one crucial part in defining and understanding amplification phenomena. The second part based on understanding, investigating and analyz...
متن کاملOptimum Pumping Configuration for L-band EDFA incorporating Selective Wavelength Auxiliary ASE from C-band EDFA
We present a thorough investigation of the optimum pumping configuration for L-band EDFA in order to maximize signal gain and minimize noise figure with forward and backward ASE pumping, by incorporating the selective property of the pump wavelength band from C-band EDFA section. A simulation of three-level rate equation has been carried out using 980 nm primary pump, 1570 nm as Lband signal wa...
متن کامل[ME01] An Efficient and Low Noise L-band Erbium-Doped Fiber Amplifier
Introduction The use of the long-wavelength-band (Lband) is attractive for both increasing the capacity of wavelength division multiplexing (WDM) systems and has been used in WDM transmission experiments at over 1 Tb/s. Recently, a gain bandwidth of about 80nm has been achieved by integrating the L-band EDFA in parallel with conventional band (Cband) EDFA [1]. Moreover, the L-band EDFAs will ma...
متن کاملEDFA and EDFL Review
ExEcutIvE Summary In this chapter, I propose a comprehensive study of erbium-doped fiber amplifier (EDFA) and erbium doped fiber laser (EDFL). The chapter is based on three principal levels: the first is at the atomic level, where it is evident and meaningful to give general and deep studies on erbium spectra at theoretical background angle. The important part that needs to be understood in the...
متن کاملPerformance Analysis of 4-Channel WDM System with and without EDFA
The Scope of this paper is to analyze the performance of 4-Channel WDM System. A WDM system forms the backbone of Optical Networks. In this paper, we have presented two configurations of WDM systems. The first configuration is without using EDFA and second configuration is using EDFA. For long distance transmission, EDFA plays a significant role in optical communication systems. The proposed co...
متن کامل