ELF/VLF wave generation from the beating of two HF ionospheric heating sources
نویسندگان
چکیده
[1] It is well established that Extremely Low Frequency (ELF, 0.3–3 kHz) and Very Low Frequency (VLF, 3–30 kHz) radio waves can be generated via modulated High Frequency (HF, 3–10 MHz) heating of the lower ionosphere (60–100 km). The ionospheric absorption of HF power modifies the conductivity of the lower ionosphere, which in the presence of natural currents such as the auroral electrojet, creates an ‘antenna in the sky.’ We utilize a theoretical model of the HF to ELF/VLF conversion and the ELF/VLF propagation, and calculate the amplitudes of the generated ELF/VLF waves when two HF heating waves, separated by the ELF/VLF frequency, are transmitted from two adjacent locations. The resulting ELF/VLF radiation pattern exhibits a strong directional dependence (as much as 15 dB) that depends on the physical spacing of the two HF sources. This beat wave source can produce signals 10–20 dB stronger than those generated using amplitude modulation, particularly for frequencies greater than 5–10 kHz. We evaluate recent suggestions that beating two HF waves generates ELF/VLF waves in the F-region (>150 km), and conclude that those experimental results may have misinterpreted, and can be explained strictly by the much more well established D region mechanism.
منابع مشابه
ELF/VLF wave generation using simultaneous CW and modulated HF heating of the ionosphere
[1] Experimental observations of ELF/VLF waves generated using the dual‐beam heating capability of the High frequency Active Auroral Research Program (HAARP) HF transmitter in Gakona, Alaska, are compared with the predictions of an ionospheric HF heating model that accounts for the simultaneous propagation and absorption of multiple HF beams. The model output is used to assess three properties ...
متن کاملModulation of auroral electrojet currents using dual modulated HF beams with ELF phase offset, a potential Dregion ionospheric diagnostic
[1] Experiments at the ionospheric heating facility of the High Frequency Active Auroral Research Program (HAARP) are performed employing dual HF beams amplitude modulated at ELF/VLF with a phase offset between the two modulation waveforms. The amplitude of the observed ELF/VLF waves is strongly dependent on the imposed ELF/VLF phase offset, the modulation waveform, and the orientation of the H...
متن کاملGeometric modulation: A more effective method of steerable ELF/VLF wave generation with continuous HF heating of the lower ionosphere
[1] ELF/VLF radio waves (300 Hz–30 kHz) are difficult to generate with practical antennae, because of their extraordinarily long (10–1000 km) wavelengths, and the lossy nature of the Earth’s surface at these frequencies. ELF/VLF waves have been successfully generated via amplitude modulated (AM) HF (2–10 MHz) heating of the lower ionosphere. Through the temperature-dependent conductivity of the...
متن کاملGeometric modulation: A new, more effective method of steerable ELF/VLF wave generation with continuous HF heating of the lower ionosphere
ELF/VLF waves can be generated via amplitude modulated HF heating of the auroral electrojet, which turns a patch of ionospheric currents into a radiating antenna. A new, more powerful technique, termed `geometric modulation', involves scanning the HF beam in geometric patterns with no power modulation. Utilizing results obtained from the HAARP facility, we show that geometric modulation enhance...
متن کاملOn the generation of ELF/VLF waves for long‐distance propagation via steerable HF heating of the lower ionosphere
[1] ELF/VLF radio waves (300 Hz to 30 kHz) have been successfully generated via modulated HF (3–10 MHz) heating of the lower ionosphere in the presence of natural currents, most recently with the HAARP facility in Alaska. Generation is possible via amplitude modulation or via two techniques involving motion of the HF beam during the ELF/VLF cycle, known as beam painting and geometric modulation...
متن کامل