The morphology of murine oncornaviruses following different methods of preparation for electron microscopy.

نویسندگان

  • N H Sarkar
  • W J Manthey
  • J B Sheffield
چکیده

The effect of different preparative procedures for electron microscopy on the size and shape of murine oncornaviruses has been studied. With conventional negative staining procedures using neutral sodium phosphotungstate, both murine mammary tumor virus and murine leukemia virus appeared in head-and-tail forms, with a peak head diameter of 122 and 130 nm, respectively. Negative staining with uranyl accetate gave round virions with peak diameters of 148 and 130 nm. Prefixed virus was round with peak diameters of 141 and 130 nm, respectively, in phosphotungstate, and 148 and 117 nm, respectively, in uranyl acetate. With thin sections, the peak diameters were 143 and 123 nm. The preservation of the spherical shape of the virus was obtained by glutaraldehyde fixation dehydration in alcholic solutions of uranyl acetate, and critical point drying. Under these conditions the viruses had peak diameters of 99 and 82 nm, respectively. The size of murine mammary tumor virus has always been found to be larger than murine leukemia virus in all preparations except for negative staining with neutral sodium phosphotungstate. Shadowing of the virion preparations revealed considerable flattening of the particles in all cases except for critical point drying. Negatively stained preparations did not cast any shadow, and thus thethickness of the particles could not be evaluated. Virus can be reversibly converted from spherical to head-and-tail forms by altering osmotic strength. Under most of the conditions used, murine mammary tumor virus gave a bimodal size distribution with significant numbers of particles that were smaller than the major virus size.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Comparative evaluation of niobium surface preparation methods for electrodeposition

To find a suitable treatment in the preparation of Nb surface for platinum electrodeposition, different methods such as thermal oxidation, anodic oxidation, mechanical roughening, and mechanical roughening with subsequent anodic etching were examined. X-ray photoelectron spectroscopy was used to study the chemical composition of depth analysis of the surface. Moreover, in order to examine the m...

متن کامل

Preparation of Different WO3 Nanostructures and Comparison of Their Ability for Congo Red Photo Degradation

Tungsten trioxide nanoparticles with monoclinic structure and average particle size about 80 nm were prepared by the spray pyrolysis method. WO3 nanorods with hexagonal structure and average dimension about 15 × 100 nm were synthesized in gram quantities by modified hydrothermal method at lower temperature and shorter reaction time in comparison to the previous research. Photo de...

متن کامل

Facile preparation of silver nanoparticles and antibacterial Chitosan-Ag polymeric nanocomposites

Silver nanostructures as an effective antibacterial materials were synthesized via three various hydrothermal, sono-chemical and microwave methods using water as a green solvent. Then Chitosan-Ag polymer based nanocomposites were made by a fast chemical procedure. The influence of power, temperature and time on the morphology and particle size of the products was investigated. Scanning electron...

متن کامل

Sonochemical Green Method for Preparation of Mg-Doped ZnO Nanostructures in Water with Enhanced Photocatalytic Activity

In this work, Mg-doped ZnO nanostructures were prepared in water under ultrasonic irradiation for 60 min without using any organic compounds or post preparation treatments. The prepared samples were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy dispersive analysis of X-ray (EDX), diffuse reflectance spectroscopy (DRS...

متن کامل

Preparation and Evaluation of Epoxy-Clay Nanocomposite Coatings for Corrosion Protection

Polymer-clay nanocomposite coatings have attracted much attention because of impressive enhancements of coating properties. In this research, both commercially available and isophoronediamine-modified montmorillonite clays were used to obtain epoxy-clay nanocomposite coatings. These nanocomposite materials with different clay loadings in the form of coatings were applied to cold-rolled steel (C...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Cancer research

دوره 35 3  شماره 

صفحات  -

تاریخ انتشار 1975