Delaminated Film Buckling Microchannels
نویسنده
چکیده
This chapter describes the method of manufacturing microfluidic microchannels formed by delaminated buckled thin films. Thin films under compression tend to delaminate and buckle. Microchannel geometry can be controlled by tailoring film residual stress and placing patterned adhesion-weakening layers utilizing photolithographic techniques. Results based on the photoresist as the adhesion weakening layer and compressed tungsten thin films are described along with the corresponding thin film mechanics.
منابع مشابه
Sub-critical telephone cord delamination propagation and adhesion measurements
Thin film delamination can occur when the stored elastic energy per unit area in the film due to the residual stress exceeds the interfacial toughness. Telephone cord morphology is commonly observed in delaminating thin films under compressive stresses. Here, the biaxial film stress is partially relieved by film buckling in the direction perpendicular to the telephone cord propagation, and by "...
متن کاملPost-buckling Analysis of Composite Plates Containing Embedded Delamination with Arbitrary Shape by Using Higher Order Shear Deformation Theory
The presence of the delamination causes reductions in the bending stiffness which in turn leads to the undesirable loss in the compressive buckling and post-buckling strength. Thus, it is of chief importance to investigate the compressive behavior of composites with delaminations. Anastasiadis et al. analyzed the buckling and postbuckling behavior of delaminated composite laminates with a throu...
متن کاملCompound Bifurcations in the Buckling of a Delaminated Composite Strut
More maths than engineering. Show how simple the model is. Mention the isotropic strut by reference. Focus on the bimaterial strut. Analysis and placement of the bifurcation. Normal form for the bifurcation? Root structure?
متن کاملBuckling Behavior of Composite Plates with a Pre-central Circular Delamination Defect under in-Plane Uniaxial Compression
Delamination is one of the most common failure modes in composite structures. In the case of in-plane compressional loading, delamination of a layered flat structure can cause a local buckling in delaminated area which subsequently affects the overall stiffness of the initial structure. This leads to an early failure of the overall structure. Moreover, with an increase in load, the delaminated ...
متن کاملCompressional Stability Behavior of Composite Plates with Multiple Through-the-Width Delaminations
In this paper, the compressive behavior of composite laminates with multiple through-the-width delaminations is investigated analytically. The analytical method is based on the CLPT theory and its formulation is developed on the basis of the Rayleigh-Ritz approximation technique to analyze the buckling and post-buckling behavior of the delaminated laminates. The method can handle both local buc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2012