The Cutting Edge
ثبت نشده
چکیده
“The bigger they are, the harder they fall” is a bit of wisdom that’s been around for a long time. But when it comes to pesticide application, the line should read, “The bigger they are, the closer they fall.” Large droplets are not as likely to drift off-target as smaller droplets. This basic principle lies behind many innovations to reduce drift when spraying herbicides. Nozzle manufacturers have been especially interested in reducing drift in recent years, as evidenced by the new products entering the market. The following are three techniques that equipment manufacturers use in designing nozzles to reduce drift.
منابع مشابه
Experimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملAn Instantaneous Rigid Force Model For 3-Axis Ball-End Milling Of Sculptured Surfaces
An instantaneous rigid force model for prediction of cutting forces in ball-end milling of sculptured surfaces is presented in this paper. A commercially available geometric engine is used to represent the cutting edge, cutter and updated part geometries. The cutter used in this work is an insert type ball-end mill. Intersecting an inclined plane with the cutter ball nose generates the cutting...
متن کاملشبیهسازی المان محدود فرایند برش متعامد و تعیین ضخامت لایه چسبنده به ابزار در ناحیه دوم برش
The built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. The built up layer (BUL) is formed in second deformation zone near the tool-chip interface in the back of the chip. This parameter influences the tool life and machined surface quality. This BUL should not be confused with the built up edge (BUE). The deformation of the BUL in...
متن کاملThe Effectiveness of Ceramic Wiper Tool in Turning of Monel K500
In this study, turning operation of Monel K500 copper-nickel super-alloy was evaluated. Ceramic cutting tools with two different cutting noses (conventional and wiper) were utilized. At first, the experimental tests were designed by using central composite design method. After implementation of the tests, the statistical models for output data (surface roughness, cutting force, and flank wear) ...
متن کاملThe Effectiveness of Ceramic Wiper Tool in Turning of Monel K500
In this study, turning operation of Monel K500 copper-nickel super-alloy was evaluated. Ceramic cutting tools with two different cutting noses (conventional and wiper) were utilized. At first, the experimental tests were designed by using central composite design method. After implementation of the tests, the statistical models for output data (surface roughness, cutting force, and flank wear) ...
متن کاملEffects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and forces in finish turning of hardened AISI H13 steel
In this study, the effects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and resultant forces in the finish hard turning of AISI H13 steel were experimentally investigated. Cubic boron nitrite inserts with two distinct edge preparations and throughhardened AISI H13 steel bars were used. Four-factor (hardness, edge geometry, feed rate and cutting ...
متن کامل