Dynamic & Static Analyses of Model of Engine Crankshaft
نویسندگان
چکیده
This study investigates dynamic & static behaviour of automotive engine crankshaft with the specific conditions. This work investigates the coupled modes, including, couple torsional flexural vibration and coupled longitudinal flexural vibration for non rotating engine crankshaft. The finite element models of this generally used are in two categories beam elements and solid elements and in this study the solid element category is being used. By using this model the natural frequencies and mode shapes of the engine crankshafts are determined by the FEM. by applying the specific load, the stress analysis of engine crankshaft is carried out by Finite element method. This study is useful to predict the safe values of dynamic as well as static behaviour of engine crankshaft.
منابع مشابه
Fatigue Analysis and Optimization of Crankshaft of V8 Diesel Engine
The crankshaft is one of the most critically loaded components as it experiences cyclic loads in the form of bending and torsion during its service life. Its failure will cause serious damage to the engine so it’s important at the time of design to verify fatigue strength. More challenges in crankshaft design due to increasing vehicle payloads, lower weight requirement, higher efficiency and lo...
متن کاملDynamic analysis of three-cylinder engine with balancing shaft
Three-cylinder linear engines are designed to minimize, reduce fuel consumption and pollution. The disadvantages of this type of engine, heavy vibration inherent in them. this study aims to balance Three-cylinder linear engines with a balancing shaft. First, the dynamic analysis of these types of engines identifies unbalanced sources. The results of the dynamic analysis showed that the inertial...
متن کاملFailure Analysis of a Four Cylinder Diesel Engine Crankshaft Made From Nodular Cast Iron
The premature breakage in some four cylinder diesel engine crankshafts was reported. All crankshafts were failed from the same region. Failures had occurred in the first crankpin, the nearest crankpin to the flywheel. Dynamic analysis and finite element modelling were carried out to determine the state of stress in the crankshaft. FEM results revealed that the first crankpin fillet is the most ...
متن کاملInvestigating The Seismic Response of Structural Walls Using Nonlinear Static and Incremental Dynamic Analyses
Structural walls commonly used as efficient structural elements to resist lateral and vertical loads. Diverse performance of bearing wall system in past earthquakes, motivates investigation on the adequacy of current seismic design provision for these walls. This study considers seismic performance of model walls of bearing wall and building frame systems designed as ordinary and special struct...
متن کاملThe Analysis of Wheel Loader Diesel Engine Crankshaft Failure
The main purpose of this study is to review the cause for the crankshaft failure of six-cylinder diesel engine of a wheel loader after passing a short period of time. The failure had occurred after 4800 hours of in-service in the fifth crankpin of the crankshaft. Hardness and tensile tests were carried out to study their mechanical properties. Spectrophotometer machine was used to examine the c...
متن کامل