Reconstruction capability of JET magnetic sensors

Reconstruction of Sea Level Changes using Magnetic Susceptibility Variations in Southeastern Caspian Sea

Magnetic susceptibility is one of the most important tools for monitoring the sediment composition during environmental studies. In this research, in order to reconstruct the Caspian Sea level changes, magnetic susceptibility variations were used during the studies of 5 sedimentary cores (K1, K3, K5, K7, N1), collected from bottom sediments of Gorgan Bay. Samples were analyzed for grain size, t...

Reconstruction of Solar Coronal Linear Force-Free Magnetic Field

Using an Appropriate Controller for Independent Current Control for Motoring of Force Windings of Bearing less Induction Motor

A bearingless induction machine has combined characteristics of induction motor and magnetic bearings. Therefore, the advantages are small size and low-cost. In the magnetic suspension of the bearingless motors, suspension forces are generated based on the feedback signals of displacement sensors detecting the movement of the rotor shaft. The suspension forces are generated taking an advantage ...

Design and Performance Analysis of a Low-cost Aided Dead Reckoning Navigator

The Federal Aviation Administration is leading the National Airspace System modernization effort, in part, by supplanting traditional air traffic services with the Global Positioning System (GPS) aided by the Wide and Local Area Augmentation Systems (WAAS & LAAS). Making GPS the primary-means of navigation will enhance safety, flexibility and efficiency of operations for all aircraft ranging fr...

A Miniaturized Nickel Oxide Thermistor via Aerosol Jet Technology

In this study, a miniaturized thermistor sensor was produced using the Aerosol Jet printing process for temperature sensing applications. A nickel oxide nanoparticle ink with a large temperature coefficient of resistance was fabricated. The thermistor was printed with a circular NiO thin film in between the two parallel silver conductive tracks on a cutting tool insert. The printed thermistor, ...