Discharge Chamber Plasma Potential Mapping of a 40-cm NEXT-type Ion Engine*

نویسندگان

  • Daniel A. Herman
  • Alec D. Gallimore
چکیده

Floating emissive probe plasma potential data are presented over a two-dimensional array of locations in the discharge chamber of a 40-cm diameter ring-cusp ion thruster. The data rule out the presence of a potential-hill plasma structure downstream of the discharge cathode assembly (DCA), which has been proposed as a mechanism of high-energy ion formation leading to DCA erosion. The discharge potential structure is dominated by the magnetic circuit, which reduces the diffusion of electrons across magnetic field lines. Shorting of the discharge keeper to discharge cathode common does not have a detectable effect on the near-DCA plasma structure outside of the keeper sheath. The plasma potential structures are insensitive to thruster throttling level with a minimum as low as 14 V at the DCA exit plane increasing gradually in the axial direction, but rising abruptly in the radial direction. A sharp increase in plasma potential to the bulk discharge value (a few volts above the discharge voltage), is observed in the radial direction past the discharge keeper edge. The existence of a free-standing plasma potential structure, termed a double layer, is found to form the transition between the low-potential plume emanating from the discharge cathode and the high-potential bulk discharge plasma. Angular-dependent sputtering yield calculations are used to estimate the NEXT DCA wear rate for the operating condition of the 2000-hr wear test. The calculated erosion rate (49 μm/khr) is slightly lower than the observed keeper erosion rate in the NSTAR 2000-hr and 8200-hr wear tests. This is due to a decreased double-to-single current ratio measured in the beam of the NEXT thruster at the wear test operating condition compared to the measured ratio in the beam of the NSTAR thruster at the full-power throttle point.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Discharge Cathode Electron Energy Distribution Functions in a 40-cm NEXT-type Ion Engine*

Electron energy distribution functions (EEDF’s) are presented over a two-dimensional array of locations in the discharge chamber of a 40-cm diameter ring-cusp ion thruster. The EEDF’s are obtained using two different techniques illustrating comparable results. A distinct difference in the EEDF’s measured through the double layer potential gradient, which transitions between the low-potential di...

متن کامل

Near Discharge Cathode Assembly Plasma Potential Measurements in a 30-cm NSTAR- type Ion Engine amidst Beam Extraction

Floating emissive probe plasma potential data are presented over a two-dimensional array of locations in the near Discharge Cathode Assembly (DCA) region of a 30-cm diameter ring-cusp ion thruster. Discharge plasma data are presented with beam extraction at throttling conditions comparable to the NASA TH Levels 8, 12, and 15. The operating conditions of the Extended Life Test (ELT) of the Deep ...

متن کامل

Discharge Chamber Plasma Structure of a 30-cm NSTAR-type Ion Engine

Single Langmuir probe measurements are presented for a two-dimensional array of locations in the near Discharge Cathode Assembly (DCA) region of a 30-cm diameter ring-cusp ion thruster over a range of thruster operating conditions encompassing the high-power half of the NASA throttling table. All data were analyzed assuming an electron population consisting of Maxwellian electrons only yielding...

متن کامل

Ion Beam Properties after Transport through an Extended Plasma Channel

Beam transport in plasma channels is a transport mechanism especially suited for the transport of high current beams or beams of poor quality (e.g. large momentum spread). It is currently studied as an alternative to ballistic focusing for final transport in ion beam driven inertial fusion reactors. Plasma channels are created by a discharge in a background gas. The channels can be initiated ei...

متن کامل

Discharge Plasma Parameters of a 30-cm Ion Thruster Measured without Beam Extraction using a High-Speed Probe Positioning System

* Presented as Paper IEPC-03-0069 at the 28 International Electric Propulsion Conference, Toulouse, France, March 17 – 21, 2003. Published by the Electric Rocket Propulsion Society with permission. † Graduate Student, Aerospace Engineering, [email protected]. ‡ Graduate Student, Aerospace Engineering. § Associate Professor and Laboratory Director. A method for delivering a symmetric double ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2005