Enhanced reflectometry measurements of permittivities and levels in layered petrochemical liquids using an “in-situ” coaxial probe
نویسندگان
چکیده
Measurement and control of the fluid parameters play a very important role in industry applications such as in the petrochemical industrial processing, where there is an increasing demand for real-time determination of dielectric parameters in relation to the product quality. Furthermore, in such a context, additional stringent requirements frequently deal with the spatial localization of non-miscible-layered liquids, like water layers often present in the bottom of tanks during the refinery industrial processing. Recently, reflectometry has become a very attractive method for monitoring applications, thanks to its accuracy and flexibility performance. In this paper, the design of a suitable probe configuration and an associated calibration structure, both leading to an optimal experimental set-up for practical reflectometry measurements in petrochemical industrial applications, are illustrated. Moreover, starting from frequency-domain reflectometry data, a robust optimization procedure is implemented and experimentally tested, thus allowing the accurate evaluation of the frequency-dependent dielectric properties and of multiple levels in different stratified liquids. Results derived through the simple time-domain technique are compared with those achieved through two different frequency-domain approaches, involving the Fast Fourier Transformation (FFT) of time-domain reflectometry (TDR) data and direct vector network analyzer (VNA) measurements, respectively. It is demonstrated that the frequency-domain approaches can significantly enhance the measurement accuracy, allowing the estimation of fuel level with an uncertainty lower than 0.5 mm. Furthermore, it is also shown that a low-cost TDR system, combined with an appropriate FFT-based algorithm, can be successfully adopted for the simultaneous measurement of permittivity and levels, without substantially affecting the measurement accuracy performance when compared to the direct frequency-domain VNA measurements. 2008 Elsevier Ltd. All rights reserved.
منابع مشابه
Preparation and Characterization of Layered Silicate Polyethylene Terephthalate Nanocomposite by in Situ Polymerization
A series of experiments on the synthesis of poly (ethylene terephthalate) (PET)/organo-montmorillonite (MMT) nanocomposites were carried out in a pressurized reactor using alkyl ammonium exchanged smectite clays, (Closite 30B).Given the degradation of organoclay at high temperatures, the in situ polymerization process was carried out at mild temperatures ranging from 210 to 230°C for 40 minutes...
متن کاملA Variable-Volume TDR Probe for Measuring Water Content in Large Soil Volumes
concluded that coaxial probe design was superior to two-wire probes with a balancing transformer. Management of favorable conditions for plant growth within parTopp and Davis (1985) extended measurement capatially wet soil volumes under drip irrigation presents a measurement bilities from a small volume (point) to multiple depths challenge. Typically, soil water status is determined from a sing...
متن کاملApplications of Artificial Neural Networks to RF and Microwave Measurements
This article describes how artificial neural networks (ANNs) can be used to benefit a number of RF and microwave measurement areas including vector network analysis (VNA). We apply ANNs to model a variety of on-wafer and coaxial VNA calibrations, including open-short-load-thru (OSLT) and line-reflect-match (LRM), and assess the accuracy of the calibrations using these ANN-modeled standards. We ...
متن کاملOpen-ended coaxial-line permittivity measurements on pulverized materials
The open-ended, coaxial-line probe technique can be used to obtain estimates of the pennittivities of some solid dielectrics over broad ranges of frequency by measurements on powdered or pulverized samples, but certain limitations must be recognized. Such a probe was used with a network analyzer to estimate the permittivities of coal and limestone from reflection coefficients measured on pulver...
متن کاملIN SITU SILICA SUPPORTED METALLOCENE CATALYSTS FOR ETHYLENE POLYMERIZATION
Bis(2-R-ind)ZrCl2 (R: H or phenyl) was supported on different types of silica by in situ impregnation method and used for ethylene polymerization. In this method, the step of catalyst loading on support was eliminated and common alkyl aluminum (triisobutylaluminum, TiBA) cocatalyst was used instead of expensive methyl aluminiumoxane (MAO) cocatalyst in the polymerization. The effect of surface ...
متن کامل