Development and application of HVOF sprayed spinel protective coating for SOFC interconnects
نویسندگان
چکیده
منابع مشابه
Copper Manganese Spinel Coating on a Ferritic Stainless Steel for SOFC Application
Nowadays, Because of daily reduction of fossil fuels and environmental problems caused by using them, Fuel Cells attracted a major attention as clean and efficient way of generating electrical power. Solid Oxide Fuel Cells (SOFCs) have many advantages to other fuel cell types. High working temperature of SOFCs caused serious challenges including high oxidation rate of interconnects, Spallation ...
متن کاملCo3O4 spinel protection coating for solid oxide fuel cell interconnect application
In the present study, electrophoretic deposition (EPD) method in different electric fields (30 – 300 V / cm) was used to apply Co3O4 spinel coating to SUS 430 as SOFC interconnect. The coated and uncoated specimens were pre-sintered in air at 800 and 900 °C for 3 h followed by cyclic oxidation at 700 and 800 °C for 500 h, respectively. X-ray diffraction analysis (XRD), Scanning Electron Microsc...
متن کاملElectrophoretic deposition of MnCr2O4 coating for solid oxide fuel cell metallic interconnects
In the present study, Mn - Cr spinel powder was synthesized through a solid state reaction. In the next step, the electrophoretic deposition (EPD) method was used to apply the MnCr2O4 spinel, as an oxidation-resistant layer, on SUS 430 stainless steel in a potential of 300 V/cm. The coated and uncoated samples were then pre-sintered in air at 900 °C for 3 h followed by cyclic oxidation at 800 °...
متن کاملOxidation and Electrical Behavior of Crofer 22APU Steel with the Co/Y2O3 Coating Produced by Direct Electroplating
Crofer 22 APU ferritic stainless steel has been evaluated as one of the favorable materials for utilization in Solid oxide fule cell (SOFC) interconnects. However, there are difficulties in utilizing these metallic interconnects, including the quick decrease of their electrical conductivity and evaporation of Cr species. To overcome the above problems, the application of protective coatings ha...
متن کاملThe Study of High Temperature Oxidation behavior of Different Microstructures of HVOF Thermally Sprayed Coatings
Improvement of thermally sprayed coating properties by microstructure modification has been considered as a significant solution. Therefore, in this research the effect of dissolved oxygen content and post heat treatment on the formation and distribution of secondary phase particles, particularly in nano-scale in the coatings during spraying and after that were studied. Ni-5 wt% Al powders were...
متن کامل