Theoretical Investigation of the Instantaneous Folding Force during the First Fold Creation in a Square Column
نویسندگان
چکیده
In this paper, a theoretical formula is presented to predict the instantaneous folding force of the first fold creation in a square column under axial loading. Calculations are based on analysis of “Basic Folding Mechanism” introduced by Wierzbicki and Abramowicz. For this purpose, the sum of dissipated energy rate under bending around horizontal and inclined hinge lines and dissipated energy rate under extensional deformations are equated to the work rate of the external force on the structure. Final formula obtained in this research, reasonably predicts the instantaneous folding force of the first fold creation versus folding distance and folding angle and also predicts the instantaneous folding force instead of the average value. Finally, according to the calculated theoretical relation, instantaneous folding force of the first fold creation in a square column was sketched versus folding distance and was compared to the experimental results which showed a good correlation. Keywords—Instantaneous force, Folding force, Honeycomb, Square column.
منابع مشابه
Experimental Investigation of the Maximum Axial Force in the Folding Process of Aluminum Square Columns
In this paper, a semi empirical formula is presented based on the experimental results to predict the first pick (maximum force) value in the instantaneous folding forceaxial distance diagram of a square column. To achieve this purpose, the maximum value of the folding force was assumed to be a function of the average folding force. Using the experimental results, the maximum value of the force...
متن کاملInvestigation of folding lateral growth using study of erosional processes and geomorphological and hydrogeological indices (Case study: Khaviz oilfield)
Recognition of growth pattern and folding mechanism in the fold-thrust belts with hydrocarbon resources is important in exploration and development planning of oilfields. As the processes of tectonics, erosion, and geomorphology impact on each other, therefore, the investigation of a process, one can obtain information about the other process. In this research the tectonic process of transverse...
متن کاملThe Effect of Lower Detachment Zone on Buckle Folds Geometry
Buckle folds are common traps for hydrocarbon in several contractional provinces. Buckle folds form where stratified sequences rest a top salt or some other utterly weak rock as a decollemet zone in units with high competency contrasts by a compressive stress which acted along the length of the rock layers. An important parameter affecting buckle folding of a competent zone above a mobile decol...
متن کاملDetermine folding mechanism of Lali structure, northern Dezful, Zagros, Iran
Lali sub-surface structure, with a NW-SE Zagros trending is located in Dezful Embayment. To determine the folding mechanism, structural geometric parameters including limbs dip, amplitude, wavelength, and crestal length were determined in four stages during deformation. In order to investigate the lateral folding mechanism, these geometric parameters were analyzed in three parts in the Lal...
متن کاملSignatures of the Balarud Deep Seated Fault Zone in Khushab Anticline, SW Iran, An Integrated Study
The Khushab anticline is located in the Zagros fold-thrust belt in the Lurestan. This anticline is affected by the Balarud fault zone, which is a part of Mountain Front Fault between the Lurestan and Dezful Embayment zones. Based on the measurement of the elements of fold style, this anticline is analyzed. According to these measurements, this anticline is a noncylindrical, asymmetrical and dis...
متن کامل