Rapid Prototyping of Transition Management Code for Reconfigurable Control Systems
نویسندگان
چکیده
This paper presents a rapid prototyping technique that focuses on transition management in hybrid systems. In particular, it integrates hybrid modeling and simulation (for specifying and validating transition strategies) with a generic transition management pattern built on a RealTime CORBA-based platform for reconfigurable control systems. Code generation is performed from the hybrid models to transition management code. This allows hybrid systems and their reconfiguration strategies to be prototyped and validated at an early stage in development and for the strategies to be directly transferred into the control system software without a separate, manual reimplementation step. The application of this work is found in most complex control systems, including the control of unmanned aerial vehicle (UAVs) performing extreme maneuvers, which is our driving application area.
منابع مشابه
Rapid Prototyping with Reconfigurable Hardware for Embedded Hard Real-Time Systems
∗ This work is supported with funds of the Deutsche Forschungsgemeinschaft within the priority program "Rapid Prototyping for Integrated Control Systems with Hard RealTime Constraints" Abstract: This paper describes a rapid prototyping system for the design and development of hard real time systems. The main focus of this rapid prototyping system is on scheduling algorithms. Issues of their imp...
متن کاملRapid-Prototyping Emulation System using a SystemC Control System Environment and Reconfigurable Multimedia Hardware Development Platform
This paper describes research into the suitability of using SystemC for rapid prototyping of embedded systems. SystemC[1][2] communication interface protocols[3][4] are interfaced with a reconfigurable hardware system platform to provide a real-time emulation environment, allowing SystemC simulations to be directly translated into real-time solutions. The consequent Rapid Prototyping Emulation ...
متن کاملMechatronic Processing Objects - Eine verarbeitungsorientierte Modellrepräsentation als Basis einer offenen Entwurfsumgebung für mechatronische Systeme
One challenge in the model-based design of mechatronic systems is to integrate a variety of different physical principles into one single, combined model of an entire system. In addition, for rapid control prototyping and hardwarein-the-loop scenarios, models need to be executed under real-time conditions, connected to real hardware. The open design environment presented here is based on proces...
متن کاملReal-Time Rapid Embedded Power System Control Prototyping Simulation Test-Bed Using LabVIEW and RTDS
When developing new control, protection, and stability methods for power systems, it is important to study the complex interactions of the system dynamics with the real-time operation of the new methods. Historically hardware prototypes were developed to study these interactions. With the recent introduction of the much cheaper rapid hardware and software prototyping tools, developers are choos...
متن کاملRapid-Prototyping Emulation System Co-emulation Modelling Interface for SystemC Real-Time Emulation
This paper describes the Communications Interface Protocol that was implemented successfully as a co-emulation modelling interface between SystemC model and a reconfigurable hardware platform. The information presented represents part of research into the suitability of using SystemC, in conjunction with a suitable reconfigurable hardware system platform, to provide a real-time emulation enviro...
متن کامل