Properties of Low-alloy High-speed Steel at Elevated Temperature
نویسنده
چکیده
J. Jaworski, T. Trzepieciński: Faculty of Mechanical Engineering and Aeronautics, Rzeszow University of Technology, Rzeszów, Poland This paper presents the results of research on the determination of the coefficient of thermal conductivity and hot hardness of cutters made of selected grades of low-alloy high-speed steels, HS 6-5-2 and HS3-1-2. The investigations of hot hardness and yield stress values of HS6-5-2 steel at elevated temperatures have shown that the hot hardness value decreased to 650 – 700 HV (59 – 60 HRC) in the temperature range of 500 – 550 °C. However, the hardness of the samples preheated to the temperature of 500 – 550 °C and measured at room temperature does not change. A decrease of the hot hardness of the steel is correlated with decreasing yield stress at elevated temperature.
منابع مشابه
The Effect of Controlled Thermo Mechanical Processing on the Properties of a High Strength Steel
In this paper, an ultra low carbon High Strength Low Alloy Grade Steel was subjected to a two-step forging process and this was followed by different post cooling methods. The highest strength was obtained at a faster cooling rate due to the highly dislocated acicular ferrite structure with the fine precipitation of microalloying carbides and carbonitrides. At a slow cooling rate, the strength ...
متن کاملEffect or Inoculation on Microstructure and Properties of Low C-Mn and Low Alloy Steels
Effect of the addition of various inoculants on the morphology and mechanical properties of low C-Mn and low alloy steel samples is studied by thermal and mechanical processing of the samples after solidification. According to the results obtained from metallographic studies with the electron microscope and microanalysis with x-rays, the distribution of inoculating agents in the steel matrix is...
متن کاملDeep Cryogenic Treatment of Alloy Steels : A Review
The word, “Cryogenics” is taken from two Greek words – “kryos” which means cold or freezing, and “genes” meaning born or generated. Technologically, it means the study and use of materials (or other requirements) at very low temperatures. In general cryogenic treatment consists of slow cooling already heat treated part to approximately -196C, holding at low temperature up to prescribed period, ...
متن کاملThe Ballistic Behavior of High Strength, Low Alloy-100 Steel at Sub-zero Temperatures
The ballistic response of the high strength, low alloy (HSLA-100) steel at ambient and temperatures of -400°C, -800°C and -1960°C is investigated in this work. Lambert-jonas equation is used to fit the experimental results into a curve. The effect of quenching on ballistic behavior of HSLA-100 is also studied. The experiments are conducted on 3mm thick rectangular specimens impacted by blunt ti...
متن کاملTHE EFFECT OF TI CONTENTS ON THE AMOUNTS OF INCLUSIONS FORMATION AND MECHANICAL PROPERTIES OF C300 HIGH STRENGTH STEEL
In this research the influence of Ti contents on the amounts of inclusions formation and mechanical properties of a high alloy high strength steel, C300, has been investigated. For this purpose several bars were casted under the same solidification conditions, but different amounts of Ti element. All the seven casted bars were homogenized at 1200°C for a period of 2 hours. Then, they were immed...
متن کامل