High Output Voltage Based Multiphase Step-Up DC-DC Converter Topology with voltage doubler rectifiers
نویسندگان
چکیده
High Output Voltage Based Multiphase Step-Up DC-DC Converter topology with voltage doubler rectifiers is presented in this paper. High output voltage is obtained due to the series combination of voltage doubler rectifiers on the secondary side of high frequency transformers. This topology is useful in the application where the output voltage is greater than the input. The two loop control strategy has been developed in order to analyze the stable and effective working of the converter topology. Therefore the working mode analysis of the converter topology has been described in detail. The multiphase step-up DCDC converter topology is first simulated on MATLAB and then a prototype has been designed in order to verify the simulation and experimental results. Finally the simulation and experimental results are found to be satisfactory.
منابع مشابه
Design and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter
A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...
متن کاملModeling and Analysis of Two-Stage Current-Mode Multiphase Voltage Doubler
A methodology about modeling and analysis of switched-capacitor-based (SC) two-stage currentmode multiphase voltage doubler (MPVD) is suggested for the low-power step-up DC-DC conversion. The SC-based converter needs no magnetic element, so the integrated circuit fabrication will be promising. This current-mode MPVD can obtain the high boosting voltage gain just by using the least number of pum...
متن کاملHigh Gain DC-DC ConverterUsing Coupled Inductor and Voltage Doubler
The output voltage obtained from renewable energy sources is low and needs to be stepped up by and order of 20 for practical usage or grid integration.This emphasizes the need for high gain DC-DC converters. The proposed DC-DC converter topology combines the simple boost converter and a coupled inductor with voltage double stages to provide high voltage gain. The main advantages of this topolog...
متن کاملDesign and Performance Evaluation of Low-Voltage/High-Current Dc/Dc On-Board Modules
The topology selection, design and performance evaluation of an on-board dc/dc converter, which delivers power from a 48-V input to a 1.2-1.65 V/70 A microprocessor load, are presented. It was shown that the symmetrical half-bridge topology with the current doubler and synchronous rectifiers is a suitable approach for this application. The measured full-load efficiency of a 200-kHz experimental...
متن کاملImplementation of Floating Output Interleaved Input DC-DC Boost Converter
This paper presents the analysin ,design and implementation of a high voltage ratio topology of DC-DC converter. The DC-DC converter has high voltage ratio with reduced input current, output voltage and output current ripple, and also reduces the voltage and current rating of power electronics components and compared with conventional boost converter. The voltage stress on the switches are red...
متن کامل