Analytical and simulation models for collaborative localization

نویسندگان

  • George Kampis
  • Jan W. Kantelhardt
  • Kamil Kloch
  • Paul Lukowicz
چکیده

Collaborative localization is a special case for knowledge fusion where information is exchanged in order to attain improved global and local knowledge. We propose analytical as well as agent based simulation models for pedestrian dead reckoning (PDR) systems in agents collaborating to improve their location estimate by exchanging subjective position information when two agents are detected close to each other. The basis of improvement is the fact that two agents are at approximately the same position when they meet, and this can be used to update local position information. In analytical models we find that the localization error remains asymptotically finite in infinite systems or when there is at least one immobile agent (i.e. an agent with a zero localization error) in the system. In the agent model we tested finite systems under realistic (that is, inexact) meeting conditions and tested localization errors as function of several parameters. We found that a large finite system comprising hundreds of users is capable of collaborative localization with an essentially constant error under various conditions. The presented models can be used for predicting the improvement in localization that can be achieved by a collaboration among several mobile computers. Besides, our results can be considered as first steps toward a more general collaborative (incremental) form of knowledge fusion. © 2014 Elsevier B.V. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

An ANOVA Based Analytical Dynamic Matrix Controller Tuning Procedure for FOPDT Models

Dynamic Matrix Control (DMC) is a widely used model predictive controller (MPC) in industrial plants. The successful implementation of DMC in practical applications requires a proper tuning of the controller. The available tuning procedures are mainly based on experience and empirical results. This paper develops an analytical tool for DMC tuning. It is based on the application of Analysis of V...

متن کامل

Collaborative Localization Algorithms for Wireless Sensor Networks with Reduced Localization Error

Localization is an important research issue in Wireless Sensor Networks (WSNs). Though Global Positioning System (GPS) can be used to locate the position of the sensors, unfortunately it is limited to outdoor applications and is costly and power consuming. In order to find location of sensor nodes without help of GPS, collaboration among nodes is highly essential so that localization can be acc...

متن کامل

A New High-order Takagi-Sugeno Fuzzy Model Based on Deformed Linear Models

Amongst possible choices for identifying complicated processes for prediction, simulation, and approximation applications, high-order Takagi-Sugeno (TS) fuzzy models are fitting tools. Although they can construct models with rather high complexity, they are not as interpretable as first-order TS fuzzy models. In this paper, we first propose to use Deformed Linear Models (DLMs) in consequence pa...

متن کامل

Optimal design of supply chain network under uncertainty environment using hybrid analytical and simulation modeling approach

Models that aim to optimize the design of supply chain networks have gained more interest in the supply chain literature. Mixed-integer linear programming and discrete-event simulation are widely used for such an optimization problem. We present a hybrid approach to support decisions for supply chain network design using a combination of analytical and discrete-event simulation models. The prop...

متن کامل

A New Approach for Stress State - Dependent Flow Localization Failure Bounded Through Ductile Damage in Dynamically Loaded Sheets

In this paper, a new approach is proposed for stress state - dependent flow localization in bifurcation failure model bounded through ductile damage in dynamically loaded sheets. Onset of localized necking is considered in phenomenological way for different strain rates to draw the forming limit diagram (FLD). Using a strain metal hardening exponent in the Vertex theory related to the strain ra...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • J. Comput. Science

دوره 6  شماره 

صفحات  -

تاریخ انتشار 2015