The Effect of Cu Additions on the Precipitation Kinetics in an Al-Mg-Si Alloy with Excess Si
نویسنده
چکیده
The microstructural evolution during age hardening of a Cu-bearing Al-Mg-Si alloy has been investigated by the three-dimensional atom probe (3DAP) and transmission electron microscope (TEM) techniques, in order to clarify the effect of Cu on the initial age-hardening response. After 30 minutes of artificial aging at 175 8C, the alloy shows a significant increase in hardness. The TEM observations have revealed that very fine, needle-shaped b 9 precipitates are formed in addition to spherical Guinier– Preston (GP) zones, whereas only the spherical GP zones are observed in the Al-Mg-Si ternary alloy using the same aging condition. The number density of the precipitates is significantly affected by the preaging conditions. The 3DAP analysis shows that the distribution of Cu atoms is uniform after 30 minutes of artificial aging at 175 8C, whereas Cu atoms are incorporated into the needle-shaped b 9 precipitates after 10 hours of aging at 175 8C. Based on these microanalytical results, the effect of Cu additions on the age-hardening response of Al-Mg-Si alloys is discussed.
منابع مشابه
THE EFFECT OF AGING ON THE CLUSTERING AND PRECIPITATION PROCESS IN Al-Mg-Si ALLOYS
The dependence of the mechanism of age hardening in Al-Mg-Si alloys on their Si content, the pre-aging conditions and addition of Cu has been investigated. For this purpose, the solute clusters and the metastable precipitates in aged Al-Mg-Si alloys have been characterized by a three dimensional atom probe (3DAP) and transmission electron microscopy (TEM). Atom probe analysis results have revea...
متن کاملTHERMAL ANALYSIS AND KINETICS OF THE PRECIPITATION IN WROUGHT Al-Mg, Al-Mg-ScAND Al-Mg-Sc-Me (Me=Zr, Ti) ALLOYS
Precipitation behaviour of wrought Al-6Mg alloys with ternary scandium and quaternary zirconium and titanium has been studied. Hardness measurements and resistivity studies are employed to assess the precipitation behaviour of scandium doped Al-6Mg alloy without or with quaternary additions of zirconium and titanium. Further, the kinetics of precipitations are studied by differential scanning c...
متن کاملTHE INFLUENCE OF DRY SLIDING ON PRCIPITATION HARDENING BEHAVIORS OF Al-Cu-Si ALLOY
Abstract: Cold working performed before an aging treatment has a significant effect on size and amount of precipitate produced. This could be caused by the increase in defect density, such as vacancies and dislocations. In this research, the Al-Cu-Si alloy was solution-treated, wear-tested and then artificially aged for a period of 1–5 h. Changes in the amount of precipitate, in the lattice par...
متن کاملبررسی اثر اکستروژن در کانال زاویه دار همسان بر رفتار پیر کرنشی دینامیکی یک آلیاژ Al-Mg-Si-Cu
An Al-Mg-Si-Cu alloy was subjected to tensile testing, both under solutionized and ECAE-ed conditions, using strain rates of 10-4 s-1 to 10-1 s-1 at temperatures of 25 ˚C to 325 ˚C to investigate the dynamic strain aging (DSA) phenomenon in the alloy. Negative strain rate sensitivity (m) and increasing ultimate tensile stress were observed in the DSA region with increasing temperature . Regardi...
متن کاملEffects of Various Ageing Heat Treatments on Microstructural Features and Hardness of Piston Aluminum Alloy
Piston aluminum alloys have different intermetallic phases, such as Cu3Al, Mg2Si ,and AlNi phases. The morphology and the distribution of such phases have important roles on mechanical properties of the piston material. Therefore, in this research, various ageing heat treatments on the mentioned material were done and the microstructural feature and the hardness were studi...
متن کامل