Beam Position Monitors Characterization for Alba
نویسندگان
چکیده
Beam position monitors (BPM) characterization has been widely studied at ALBA Synchrotron Light Source. Special care has been taken on the analysis of their electrical offset in order to achieve submicron beam stabilities. This paper shows the results of the BPM offset study for Booster and Storage Ring. The electrical effect of the different vacuum vessels housing the BPMs is also reported.
منابع مشابه
Cavity Beam Position Monitors
Beam-based alignment and feedback systems are essential for the operation of future linear colliders and free electron lasers. A certain number of beam position monitors with a resolution in the submicron range are needed at selected locations. Most beam position monitors detect the electric or the magnetic eld excited by a beam of charged particles at di erent locations around the beam pipe. I...
متن کاملOptimization of Small Aperture Beam Position Monitors for Nsls-ii Project*
The NSLS-II Light Source is being built at Brookhaven National Laboratory. It will provide users with ultimate brightness beam and full realization of its capabilities requires corresponding stability of the beam orbit. The small aperture beam position monitors (BPMs) will provide better sensitivity to the beam position but also requires thorough design. In this paper we present the results of ...
متن کاملCVD diamond-based semi-transparent beam-position monitors for synchrotron beamlines: preliminary studies and device developments at CEA/Saclay.
Polycrystalline diamond synthesized using the chemical vapour deposition (CVD) technique can be used to fabricate new types of photodetectors for the characterization of X-ray light in synchrotron beamlines. Since diamond exhibits a low absorption to low-energy photons, such devices allow beam-position monitoring with very little beam attenuation at photon energies as low as 2 keV up to 15-20 k...
متن کاملOptics Measurement at the Interaction Point Using Nearby Position Monitors in Kekb
Optics parameters at the interaction point, beta, x-y coupling, dispersion and their chromatic aberrations, seriously affect the beam-beam performance as is shown in experiments and simulations. The control of the optics parameters is essential to maintain the high luminosity in KEKB. They drift day by day, or before and after the beam abort. They were often monitored at intervals of the operat...
متن کاملCavity-type Beam Position Monitors for the SASE FEL at the TESLA Test Facility
Cavity-type beam position monitors were developed to measure the beam alignment at the undulator section of DESY’s TESLA Test Facility (TTF). This paper describes some theoretical aspects and the experimental setup. The results of some in-beam measurements at the TTF are presented and pros and cons of the monitor concept are discussed.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2010