Study on damping capacity and dynamic Young’s modulus of aluminium matrix composite reinforced with SiC particles
نویسندگان
چکیده
The development of high damping materials for noise reduction and attenuation of vibration on structural applications, such as automotive and aerospace industries, has been investigated. This experimental study is concerned with the damping capacity (tan delta) and dynamic Young’s modulus (|E*|) of Silicon carbide (SiC) reinforced aluminium (Al) matrix composite. AlSi-SiCp composite was produced by hot pressing technique. Damping capacity and dynamic Young’s modulus of composite and unreinforced AlSi alloy were studied using a dynamic mechanical analyser (DMA), over a temperature range of room temperature400oC (during heating and cooling phases), at 1 and 20 Hz. AlSi-SiCp composite showed higher damping capacity and dynamic Young’s modulus than the AlSi unreinforced alloy. Furthermore, damping capacity was found to increase with temperature, while modulus decreases. The possible damping mechanisms are presented and discussed. © 2017 Portuguese Society of Materials (SPM). Published by Elsevier España, S.L.U.. All rights reserved.
منابع مشابه
Study of the Enhanced Precipitation of an Aluminium 6061 Alloy Reinforced by SiC Particles in the Range of β\" Phase Temperature (RESEARCH NOTE)
An experimental method to follow the evolution of the precipitation phenomena in the metal-matrix composites using the thermoelectric power measurements is described. It is shown that one can follow the kinetics of the precipitation during aging. The influence of the reinforcement on the precipitation kinetics is studied in case of an aluminum 6061- SiC, composite (where SiC, represents SiC par...
متن کاملEffect of Varying Silicon Carbide Particulate on the Mechanical Properties of Aluminium Based Alloy Automobile Brake Disc Component
In the current study, effect of varying Silicon Carbide particulate on the mechanical properties of Aluminium based alloy automobile brake disc component was investigated. The result of experimental investigation on mechanical properties of Silicon Carbide particle reinforced Aluminium Matrix was achieved for composite brake disc using universal tensile test machine, Rockwell hardness testing m...
متن کاملEffect of texture evolution on mechanical and damping properties of SiC/ZnAl2O4/Al composite through friction stir processing
In this investigation, special consideration was given to observe the influence of the acquired ultra-fine-grain (UFG) structure through friction stir processing (FSP) on mechanical and damping properties. As the mechanical behaviour of the composites are intensely related to their microstructure. For deeply understanding the possible mechanism and detailed microstructural observations at a lon...
متن کاملEffect of Particle Volume Fraction on the Tensile Properties of Composite Al6061/SiC Materials by Hot Extrusion
In the present study the effect of phase volume fraction on the reinforcement of microstructure and tensile properties of composite extrusion process Al6061/SiC has been studied. For this purpose, the base alloy Al6061 using pure aluminum ingots, silicon, of Al-50% Mg, Al-10% Cr and a thin copper rod was prepared. Next, the composite Al6061/5% SiC, Al6061/10% SiC, Al6061/15% SiC and Al6061/20% ...
متن کاملPrediction of the Thermomechanical Behavior ofParticle-Reinforced Metal Matrix Composites
The objective of this paper was to predict the thermomechanical behavior of 2080 aluminum alloy reinforced with SiC particles using the Mori–Tanaka theory combined with the finite element method. The influences of particle volume fraction, stiffness, aspect ratio and orientation were examined in terms of effective Young’s modulus, Poisson’s ratio and coefficient of thermal expansion (CTE) of th...
متن کامل