Solar Energy Collection using a Double-layer Roof
نویسنده
چکیده
The purpose of this study is to investigate the efficiency of a double-layer roof in collecting solar energy as an application to the areas such as raising high-end temperature of organic Rankine cycle (ORC). The by-product of the solar roof is to reduce building air-conditioning loads. The experimental apparatus are arranged to evaluate the effects of the solar roof in absorbing solar energy. The flow channel is basically formed by an aluminum plate on top of a plywood plate. The geometric configurations in which the effects of absorbing energy is analyzed include: a bare uncovered aluminum plate, a glass-covered aluminum plate, a glass-covered/black-painted aluminum plate, a plate with variable lengths, a flow channel with stuffed material (in an attempt on enhancement of heat conduction), and a flow channel with variable slanted angles. The experimental results show that the efficiency of energy collection varies from 0.6 % to 11 % for the geometric configurations mentioned above. An additional study is carried out using CFD simulation to investigate the effects of fins on the aluminum plate. It shows that due to vastly enhanced heat conduction, the efficiency can reach ~23 % if 50 fins are installed on the aluminum plate. The study shows that a double-layer roof can efficiently absorb solar energy and substantially reduce building air-conditioning loads. On the high end of an organic Rankine cycle, a solar pond is used to replace the warm surface water of the sea as OTEC (ocean thermal energy conversion) is the driving energy for the ORC. The energy collected from the double-layered solar roof can be pumped into the pond and raise the pond temperature as the pond surface area is equivalently increased by nearly one-fourth of the total area of the double-layer solar roof. The effect of raising solar pond temperature is especially prominent if the double-layer solar roofs are installed in a community area. Keywords—solar energy collection, double-layer solar roof, energy conservation, ORC, OTEC
منابع مشابه
Design and Simulation of a Highly Efficient InGaN/Si Double-Junction Solar Cell
A solar cell is an electronic device which not only harvests photovoltaic effect but also transforms light energy into electricity. In photovoltaic phenomenon, a P-N junction is created to form an empty region. The presented paper aims at proposing a new highly efficient InGaN/Si double-junction solar cell structure. This cell is designed to be used in a real environmental situation, so only s...
متن کاملEfficiency Enhancement of Si Solar Cells by Using Nanostructured Single and Double Layer Anti-Reflective Coatings
The effect of single and double-layer anti-reflective coatings on efficiency enhancement of silicon solar cells was investigated. The reflectance of different anti-reflection structures were calculated using the transfer matrix method and then to predict the performance of solar cells coated by these structures, the weighted average reflectance curves were used as an input of a PC1D simulation....
متن کاملMulti Objective Optimization on Insulated Residential Roof with Solar Water Heating System Using Grey Relation Analysis (RESEARCH NOTE)
In this work, a multi-objective optimization on novel insulated roof with solar water heating system at low material cost has been carried out through Taguchi based grey relational analysis technique. The novel roofs have concrete, insulating polyurethane, and a channel of water in a metallic pipe tunneling the chromium block. Chromium block is used to conduct more heat to raise the water to re...
متن کاملRoof Integrated Solar Absorbers: The Measured Performance of “Invisible” Solar Collectors: Preprint
The Florida Solar Energy Center (FSEC), with the support of the National Renewable Energy Laboratory (NREL), has investigated the thermal performance of solar absorbers which are an integral yet indistinguishable part of a building’s roof. The first roof-integrated solar absorber (RISA) system was retrofitted into FSEC’S Flexible Roof Facility in Cocoa, Florida in September 1998. This “proof-of...
متن کاملFabrication of dye sensitized solar cells with a double layer photoanode
Dye sensitized solar cell was fabricated from a double layer photoanode. First, TiO2 nanoparticles were synthesized by hydrothermal method. These TiO2 NPs were deposited on FTO glasses by electrophoretic deposition method in applied voltage of 5 V and EPD time of 2.5-10 min. Then TiO2 hollow spheres (HSs) were synthesized by sacrificed template method with Carbon Spheres as template and TTIP ...
متن کامل