The thermally induced metal-semiconducting phase transition of samarium monosulfide (SmS) thin films.

نویسندگان

  • E Rogers
  • P F Smet
  • P Dorenbos
  • D Poelman
  • E van der Kolk
چکیده

High quality phase pure samarium monosulfide (SmS) thin films were prepared by electron beam evaporation using a samarium metal source in a H(2)S atmosphere. The optical properties (reflection, transmission, absorption) of the films in the semiconducting and metallic phase were analysed from the UV to the mid-IR and explained in terms of the electronic structure of SmS. In this paper it will be shown that metallic SmS thin films exhibit an apparently continuous thermally induced metallic to semiconducting phase transition when studied optically. Temperature dependent x-ray diffraction measurements, however, indicate that the metallic to semiconductor phase transition is in fact first order at a single grain level. The apparently continuous optical behaviour is therefore due to the polycrystalline nature of the films.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Samarium Monosulfide (SmS): Reviewing Properties and Applications

In this review, we give an overview of the properties and applications of samarium monosulfide, SmS, which has gained considerable interest as a switchable material. It shows a pressure-induced phase transition from the semiconducting to the metallic state by polishing, and it switches back to the semiconducting state by heating. The material also shows a magnetic transition, from the paramagne...

متن کامل

Metal-Insulator Transition of strained SmNiO3 Thin Films: Structural, Electrical and Optical Properties

Samarium nickelate (SmNiO3) thin films were successfully synthesized on LaAlO3 and SrTiO3 substrates using pulsed-laser deposition. The Mott metal-insulator (MI) transition of the thin films is sensitive to epitaxial strain and strain relaxation. Once the strain changes from compressive to tensile, the transition temperature of the SmNiO3 samples shifts to slightly higher values. The optical co...

متن کامل

Thermal Annealing Influence over Optical Properties of Thermally Evaporated SnS/CdS Bilayer Thin Films

Thin films of tin sulfide/cadmium sulfide (SnS/CdS) were prepared bythermal evaporation method at room temperature on a glass substrate and then annealedat different temperature with the aim of optimizing the optical properties of the materialfor use in photovoltaic solar cell devices. The effect of annealing on optical propertiesof SnS/CdS film was studied in the temper...

متن کامل

Annealing temperature effect on nanostructure and phase transition of Copper Oxide thin films

This paper addresses the annealing temperature effect on nanostructure and phase transition of copper oxide thin films, deposited by PVD method on glass substrate (at 110 nm thickness) and post annealed at different temperatures (200-400°C) with a flow of 1 cm3s-1 Oxygen. The X-ray diffraction (XRD) was employed for crystallographic and phase analyses, while atomic force m...

متن کامل

Intense Red Catho- and Photoluminescence from 200 nm Thick Samarium Doped Amorphous AlN Thin Films

Samarium (Sm) doped aluminum nitride (AlN) thin films are deposited on silicon (100) substrates at 77 K by rf magnetron sputtering method. Thick films of 200 nm are grown at 100-200 watts RF power and 5-8 m Torr nitrogen, using a metal target of Al with Sm. X-ray diffraction results show that films are amorphous. Cathodoluminescence (CL) studies are performed and four peaks are observed in Sm a...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Journal of physics. Condensed matter : an Institute of Physics journal

دوره 22 1  شماره 

صفحات  -

تاریخ انتشار 2010