Evaluation of Morphology and Deformation Micromechanisms in Multilayered PP/PS Films: An Electron Microscopy Study

Nanostructured polymers and ultra-thin polymer layers are used more and more in technical applications like nanotechnology and microelectronics. Therefore, it is really important to understand the size-scale dependent properties as bulk polymers become thinner and more two-dimensional. Here the morphology as well as the macroscopic and the microscopic deformation behaviour of multilayered films of polypropylene (PP) and polystyrene (PS) have been investigated. For investigation different microscopic techniques and tensile testing were used. The films were prepared by multilayer coextrusion, whereas the composition of PP and PS and the film thickness – and therefore the thickness of each layer – varied. The thinnest calculated thickness of a single layer was about 5 nm. It is shown that the PP/PS films consist usually of homogeneous layers with only few defects. As the composition of PP/PS deviates strongly from 50/50 or the films get thinner the number of defects increases and the layered system turns to irregular lamellar system. In macroscopic tensile tests the small PS layers affect the elongation at break enormously: Most of the samples are brittle. For the films with a composition of PP/PS 90/10 and the film PP/PS 70/30 with a film thickness of 25mm an elongation at break of 66% and higher could be reached. Transmission electron microscopy on these samples shows that the layers are characterized by plastic yielding in local deformation zones.