Foam Generation in Rotor-Stator Mixers

نویسنده

  • J Groot Wassink
چکیده

non-ideality, it will tend to reduce differences between calibraiion and predictior;. To do this of course is not always possible, particularly where the effect of changing dyebath conditions is under consideration, e.g. liquor ratio, electrolyte concentration, pH and dye concentration. To attempt calibration experiments to adequately cover the results of such changes would remove the need for prediction. If one of the changes in conditions anticipated is that of ternperature then obviously the calibration experiments would have to include a measure of the heats of dyeing of the dyes concerned, so that the affinities used would be correct or correctable to the temperatures involved. It may be considered that the treatment developed presents something of an 'over-kill', particularly in terms of the determination of the amounts of all the different ionic species in the system originating from a variety of sources. For many dyeing systems this is indeed true, i.e. in dyebaths of high liquor ratio and in the presence of moderate to high concentrations of added electrolyte, where the adventitious contribution of ions from other sources could be negligible. On the other hand there are other cases where such considerations would be warranted, e.g. when dyeing a fibre such as wool, which has a considerable potentiality t o contribute ions, at low liquor ratios with the minimum addition of electrolyte. Since the application of the treatment clearly calls for the use of a computer there should be no problems in covering all eventualities, apart from the increased complexity of the computer program. However, once written, the program can be used in the general sense if so desired or in a suitably modified way by using the appropriate data input. The equations produced are complex and if the only method of evaluation available was by manual calculation then the time required would be a serious obstacle to their usefulness in practical circumstances. However, the continuing development of computers has totally removed this difficulty, so much so that the practical use of these methods could well be an online procedure once the necessary computer programs are available.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Electrostatic interactions between rotor and stator in the bacterial flagellar motor.

Bacterial flagellar motors rotate, obtaining power from the membrane gradient of protons or, in some species, sodium ions. Torque generation in the flagellar motor must involve interactions between components of the rotor and components of the stator. Sites of interaction between the rotor and stator have not been identified. Mutational studies of the rotor protein FliG and the stator protein M...

متن کامل

Nusselt Number Measurement of Air Flow between Grooved Rotor and Stator of a Generator

In this article, turbulent flow heat transfer in the air gap between rotor and stator of a generator under nonhomogeneous heat flux is studied experimentally. The rotor consists of four symmetrical triangular grooves. The stator surface is smooth and does not include any grooves. The relative heat flux between the rotor and the stator is 1 to 3. Temperature and heat flux are measured locally at...

متن کامل

A Novel Rotor and Stator Magnetic Fields Direct- Orthogonalized Vector Control Scheme for the PMSM Servo System

Permanent Magnet Synchronous motor (PMSM) has received widespread acceptance in recent years. In this paper, a new rotor and stator Magnetic Fields Direct-Orthogonalized Vector Control (MFDOVC) scheme is proposed for PMSM servo system. This method simplified the complex calculation of traditional vector control, a part of the system resource is economized. At the same time, through the simulati...

متن کامل

Nusselt Number Measurement of Air Flow between Grooved Rotor and Stator of a Generator

In this article, turbulent flow heat transfer in the air gap between rotor and stator of a generator under nonhomogeneous heat flux is studied experimentally. The rotor consists of four symmetrical triangular grooves. The stator surface is smooth and does not include any grooves. The relative heat flux between the rotor and the stator is 1 to 3. Temperature and heat flux are measured locally at...

متن کامل

Investigation of Coupling of EMC Disturbances in Doubly Fed Induction Generators

In renewable power generation doubly fed induction generators (DFIG) are used, in which the stator of the generator is directly connected to mains, while the converter for the rotor is rated only for slip power. Due to the interaction of rotor and stator windings in a DFIG, the high-frequency harmonics caused by the pulsed output of rotor power converters are transmitted into the stator current...

متن کامل

Predictive Control of Induction Motor Drive Using Dspace

Since the induction motor drives have gained its popularity among regulated drives area, the great effort is put on increasing their efficiency. The use of predictive algorithm to control their speed is becoming a popular approach that preserves high efficiency. This paper presents implementing predictive control on the dSPACE DS1103 system, where the dSPACE is the control part of the system, d...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2008