Effect of different photoactivation techniques on the bond strength of a dental composite.
نویسندگان
چکیده
Using the push-out test, this study evaluated the bond strength of the composite resin Z250 (3M/ESPE) photoactivated with the XL2500 (3M/ESPE) quartz-tungsten-halogen light-curing unit with different curing protocols: soft-start (150 mW/cm² for 2 s (S2), 3 s (S3), 5 s (S5), 10 s (S10) or 15 s (S15), followed by 700 mW/cm² for 15 s; pulse-delay (150 mW/cm² for 2 s (P2), 3 s (P3), 5 s (P5), 10 s (P10) or 15 s (P15), with a 1-min delay, followed by 700 mW/cm² for 15 s. After storage at 37°C ± 1 for 24 h ± 1, the specimens were ground, polished and subjected to a push-out test in a universal test machine (Instron) with a cell load of 500 N at a crosshead speed of 0.5 mm/min. The data were analyzed statistically by ANOVA and Tukey's test at 5% significance level. There were no statistically significant differences (p>0.05) among the groups photoactivated using the soft-start mode. For the pulse-delay mode, P5 promoted the highest bond strength (p<0.05). Groups photoactivated with the pulse-delay mode (except for P2 and P15) presented significantly higher bond strength than those photoactivated with the soft-start. It may be concluded that the influence of initial exposure time was curing method-dependent, with the best results obtained using the pulse-delay method with 5 s in the first photoactivation cycle.
منابع مشابه
Effect of Zinc Oxide-Eugenol Temporary Restorations on Bond Strength of Composite Resin
Introduction: Effect of zinc oxide-eugenol (ZO-E) on bond strength of composite is equivocal. The aim of the present study was to determine if ZO-E affects shear bond strength. Methods: For the purposes of the study, extracted human molar teeth were ground so thatcomposite rods could be bonded to dentine. In group 1, dentine was not exposed to ZO-E. In group 2,...
متن کاملEvaluation of microtensile bond strength of repaired dental resin composite using different surface treatment techniques: A laboratory study
Background and Aims: Today, resin composites are one of the most commonly used materials in restorative dentistry. However, failure in resin treatments is also common due to its chemical nature and its high talent for decay recurrence. According to conservative approaches, "conservative" treatments are more likely to be considered than "Replacement" of damaged remedies. The purpose of this stud...
متن کاملIn Vitro Effects of Different Surface Preparation Techniques on Shear Bond Strength of Direct to Indirect Composite Resin
Objective: Repair of an indirect restoration is usually preferred over its replacement. This study aimed to evaluate the effect of silane in different surface preparation techniques on the bond strength of direct to indirect composite resin. Methods: For this in vitro experimental study, 48 indirect composite cubes were fabricated, divided into 4 groups of 12 and subjected to the following ...
متن کاملComparison of Shear Bond Strength of Composite Restorations to Intact Enamel of Primary Incisors When Using Different Conditioners and Adhesive Systems
Introdouction: Esthetic demands of patients have led to the introduction of tooth-colored restorations wherecomposite resins are bonded to the enamel using acid etch techniques. Total etch adhesion systems are still considered as the gold standard among bonding systems. However, clinicians have a tendency to use adhesive systems with simpler application procedures. The aim of the present stu...
متن کاملEvaluation of the Effect of Sodium Hypochlorite Irrigant on Pull-out Bond Strength of FRC Posts Using Different Resin Cements
Introduction: To evaluate the effects of using sodium hypochlorite irrigant on pull-out bond strength of self-etch and self-adhesive resin cements to dentin. Methods: Sixty intact premolars were decoronated and the root canals were prepared by step-back technique. The teeth were divided into two groups according to the irrigant used during root canal treatment: 5.25% sodium hypochlorite and nor...
متن کاملEffect of Storage Media and Sterilization Method on Shear Bond Strength of Composite to Enamel of Extracted Teeth
Aim: To evaluate the effect of storage media and autoclaving on shear bond strength of composite to enamel. Materials and Methods: 100 human premolars were randomly divided into ten groups of ten as follows: C: freshly extracted teeth. A: Autoclaved freshly extracted teeth. CH-6: 6 month storage in 0.5 % chloramine T. CA-6: 6 month storage in 0.5 % chloramine T + autoclaving. T-6: 6 month stora...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Brazilian dental journal
دوره 21 3 شماره
صفحات -
تاریخ انتشار 2010