Bootstrapped low-voltage analog switches
نویسنده
چکیده
Novel low-voltage constant-impedance analog switch circuits are proposed. The switch element is a single MOSFET, and constantimpedance operation is obtained using simple circuits to adjust the gate and bulk voltages relative to the switched signal. Low-voltage (1-volt) operation is made feasible by employing a feedback loop. The gate oxide will not be subject to voltages exceeding the supply voltage difference. Realistic switches have been simulated with HSPICE. The simulations show that the switch circuits operate very well, even when the supply voltage approaches the technology’s threshold voltage.
منابع مشابه
Low-Voltage Analog Switch in Deep Submicron CMOS: Design Technique and Experimental Measurements
This paper concerns the design, implementation and subsequent experimental validation of a low-voltage analog CMOS switch based on a gate-bootstrapped method. The main part of the proposed circuit is a new low-voltage and low-stress CMOS clock voltage doubler. Through the use of a dummy switch, the charge injection induced by the bootstrapped switch is greatly reduced resulting in improved samp...
متن کاملA 12-bit CMOS Ratio-Independent Algorithmic Analog-to-Digital Converter
This paper proposes a 1.5 V 12-b CMOS ratio-independent algorithmic analog-to-digital converter (ADC) based on a capacitor-mismatch insensitive technique. A novel switched-capacitor multiplying digital-to-analog converter (MDAC) with an accurate gain of two is proposed for an algorithmic ADC. The proposed MDAC architecture requires only one opamp in four phases to generate the next residue outp...
متن کاملLow-Voltage/Low-Power CMOS For High Precision Sample-and-Hold Circuit
This paper presents a sample-and-hold circuit based on a novel implementation of the bootstrapped low-voltage analog CMOS switch. The heart of this circuit is a new low-voltage and low-stress CMOS clock voltage doubler. Through the use of a dummy switch, the charge injection induced by the bootstrapped switch is greatly reduced resulting in improved sample-and-hold accuracy. Simulation results ...
متن کاملA Study to Realize a 1-V Operational Passive Σ-Δ Modulator by Using a 90 nm CMOS Process
A 1-V operational sigma-delta modulator with a second-order passive switched capacitor filter is designed and fabricated by using a 90 nm CMOS process. No gate-voltage bootstrapped scheme is adopted to drive analog switches, and the voltage gain of a comparator is chosen to be 94 dB. The experimental results show that the peak SNR reached 68.9 dB with a frequency bandwidth of 40 kHz when the cl...
متن کاملA New Single-phase Symmetrical Cascade Multilevel Inverter with Low Number of Power Switches
In this paper a new 5-level single phase symmetrical cascade multi-level inverter is proposed. The proposed topology contains combination of unidirectional and bidirectional power switches based on output voltage level number. The number of power switches and withstanding voltage of powers witches were reduced related to the other topologies. This configuration can be extended to the n-level in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1999